Digital Audio Labs LIVEMIX DA-816 Manuale d'uso - Pagina 9
Sfoglia online o scarica il pdf Manuale d'uso per Sistema di altoparlanti Digital Audio Labs LIVEMIX DA-816. Digital Audio Labs LIVEMIX DA-816 13.
Anche per Digital Audio Labs LIVEMIX DA-816: Manuale d'uso (13 pagine)
Stampa la pagina
SETUP AND OPERATION
The DA-816 output box allows users to send their personal mixes to wireless in-ear transmitters,
powered monitors, or powered house speakers. The DA-816 connects to the MIX-16/32 via a
shielded CAT5/CAT6 network cable. Each DA-816 provides eight stereo outputs. Any CS-DUO
personal mix can be assigned to one or more of these eight stereo outputs.
CONNECTING A SINGLE DA-816 TO A MIX-16/32
1. Attach the 12VDC external power supply to the DA-816
external power supply connector.
2. Insert a shielded CAT5/CAT6 network cable into the
LIVEMIX DATA OUT 1 on the MIX-16/32.
3. Connect the other end of the network cable to the LIVEMIX
DATA IN port on the DA-816.
CONNECTING TWO DA-816 UNITS TO A MIX-32
For installations that require more than 8 stereo outputs, use the
MIX-32 with two DA-816 units for up to 16 stereo outputs.
1. Attach the 12VDC external power supply to the DA-816
external power supply connector.
2. Connect the first DA-816 as described above.
3. Insert a second sheilded CAT5/CAT6 network cable into the
LIVEMIX DATA OUT 2 on the MIX-32.
4. Connect the other end of the network cable to the LIVEMIX
DATA IN port on the second DA-816.
CONNECTING THE TRS OUTPUTS TO AN EXTERNAL DEVICE
The DA-816 analog outputs can send any CS-DUO mix to any external balanced analog input.
Most often this will be a wireless in-ear monitor system. The DA-816 outputs are labeled 1-8
corresponding to the 8 outputs on the CS-DUO Mix Assign page
(see below).
1. The TRS connectors on the back of the DA-816 are labeled
to correspond with the assignable outputs. Connect
balanced TRS cables from the desired output to the external
device.
2. Use the CS-DUO to assign mixes to the outputs.
LIVEMIX DA-816
NOTE:
If you are using a MIX-32 and
a single DA-816, it MUST be
connected to LIVEMIX DATA
OUT 1. Connecting to LIVEMIX
DATA OUT 2 will not function
properly.
NOTE:
When using two DA-816s with
the MIX-32, you can assign any
of the available CS-DUO mixes
to any of the DA-816 output
ports. All of the available mixes
will be available on both the
LIVEMIX DATA OUT ports.
NOTE:
For external devices that only
have mono inputs, change the
CS-DUO to BALANCED MONO
mode after assigning the mixes.
This will send the same mono
signal out of both TRS jacks for
the assigned output.
6