Crestron 4 Series Avvio rapido - Pagina 2

Sfoglia online o scarica il pdf Avvio rapido per Sistemi di controllo Crestron 4 Series. Crestron 4 Series 5. Control processor for zūm lighting control system
Anche per Crestron 4 Series: Manuale di avvio rapido (8 pagine), Manuale di avvio rapido (8 pagine), Manuale di avvio rapido (6 pagine), Manuale di avvio rapido (6 pagine), Manuale di avvio rapido (6 pagine), Manuale di avvio rapido (2 pagine), Manuale di avvio rapido (2 pagine), Come iniziare (2 pagine), Manuale di avvio rapido (2 pagine), Manuale di avvio rapido (12 pagine)

CP4/CP4N

4-Series Control System

Connect the Device

Make all necessary connections to the control system as shown below.

Observe the following when connecting the control system:

Use Crestron power supplies for Crestron equipment.

The control system may be powered with the included 24 VDC power

supply or via Cresnet® network power with the NET port.

Connect the chassis ground lug to a known earth ground circuit (such

as building steel) to ensure that the control system is grounded

properly.

Apply power after all connections have been made.

COM 1 Connections

Port

RS-232

GND

TX (from CP4/CP4N)

RX (to CP4/CP4N)

RTS

RTS (from CP4/CP4N)

CTS

CTS (to CP4/CP4N)

1. RS-422 transmit and receive are balanced signals that require two lines plus a ground

in each direction. RXD+ and TXD+ should idle high (going low at start of data

transmission). RXD- and TXD- should idle low (going high at start of data

transmission). If necessary, RXD+/RXD- and TXD+/TXD- may be swapped to maintain

correct signal levels.

2. A ground terminal connection is recommended but not required.

Quick Start

RS-422

RS-485

GND

TX- (from CP4/CP4N)

TX-/RX-

RX+ (to CP4/CP4N)

Not used

TX+ (from CP4/CP4N)

TX+/RX+

RX- (to CP4/CP4N)

Not used