Digital Barriers EDGEVIS HD-IP450 Manuale di installazione - Pagina 15
Sfoglia online o scarica il pdf Manuale di installazione per Automobile Accessories Digital Barriers EDGEVIS HD-IP450. Digital Barriers EDGEVIS HD-IP450 16.
Stampa la paginaEDGEVIS HD-IP450 HARDWARE INSTALLATION GUIDE
FCC COMPLIANCE
This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with instructions, may cause harmful interference to radio communications. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following:
•
Reorient or relocate the receiving antenna
•
Increase the separation between the equipment and receiver
•
Connect the equipment to an outlet on a circuit different from that to which the receiver is connected
The EdgeVis HD-IP450 unit contains a radio module that has been FCC Approved for fixed and mobile applications (FCC ID: RI7UC864G).
The radio module conforms to the following US Directives;
•
Use of RF Spectrum. Standards: FCC 47 Part 22
•
Use of RF Spectrum. Standards: FCC 47 Part 24
•
EMC (Electromagnetic Compatibility). Standards: FCC47 Part 15
The EdgeVis HD-IP450 Encoder contains a radio module that has been FCC Approved for fixed and mobile applications (FCC ID: ZCN722MV1).
The radio module conforms to the following US Directive;
•
Use of RF Spectrum. Standards: FCC 15 Part C.
FCC Warning: changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the
equipment.
To meet the FCC's RF exposure rules and regulations:
•
The use of a non-shielded interface cable with the EdgeVis HD-IP450 Encoder device is prohibited
•
The power cord must be 3m (10 feet) or less in length and a ferrite should be fitted within 5cm (2 inches) of the equipment
•
The antenna(s) used with the EdgeVis HD-IP450 unit must be installed to provide a separation distance of at least 20cm (8 inches) from all persons
and must not be co-located or operating in conjunction with any other antenna or transmitter
•
The antenna(s) used with the EdgeVis HD-IP450 unit must not exceed 3dBi
The EdgeVis HD-IP450 unit shall only be used for fixed and mobile applications.
CE COMPLIANCE STATEMENT
The EdgeVis HD-IP450 Encoder complies with the following European Union Directives:
•
Low Voltage Directive 2006/95/EEC for product safety
•
Directive 89/336/EEC for EMC conformity
The EdgeVis HD-IP450 Encoder contains a radio module that has been approved for integration into fixed and mobile applications. The r a d i o m o d u l e
conforms to the following European Union Directives:
•
R&TTE Directive 99/05/EC (Radio Equipment & Telecommunications Terminal Equipment)
•
Low Voltage Directive 73/23/EEC for product safety
•
Directive 89/336/EEC for EMC conformity
In order to satisfy the essential requisite of the R&TTE 99/05/EC directive, the radio module is compliant with the following standards:
•
Radio Spectrum, Standard: EN 301 511, EN 301 908-1 and EN 301 908-2
•
EMC (Electromagnetic Compatibility). Standards: EN 301 489-1, EN 301 489-7 and EN 301 489-24
•
LVD (Low Voltage Directive) Standards: EN 60950-1:2001+A11:2004
The use of this product may be dangerous and has to be avoided in the following areas:
•
Where it can interfere with other electronic devices in environments such as hospitals, airports, aircraft, etc.
•
Where there is risk of explosion such as gasoline stations, oil refineries, etc.
The user must ensure that:
•
The antenna(s) used with the EdgeVis HD-IP450 unit must be installed to provide a separation distance of at least 20cm from all persons and must
not be co-located or operating in conjunction with any other antenna or transmitter
•
The antenna(s) used with the EdgeVis HD-IP450 unit must conform to the requirements stated in the installation guide
•
The EdgeVis HD-IP450 unit shall only be used for fixed and mobile applications
It is responsibility of the user to enforce the country regulations and specific environment regulations.
ISSUED: 10 NOVEMBER 2020
PAGE 15