Digital Barriers EDGEVIS HD-IP450 Manuale di installazione - Pagina 6

Sfoglia online o scarica il pdf Manuale di installazione per Automobile Accessories Digital Barriers EDGEVIS HD-IP450. Digital Barriers EDGEVIS HD-IP450 16.

Stampa la pagina

EDGEVIS HD-IP450 HARDWARE INSTALLATION GUIDE

Powering the device and switching it on/off

The HD-IP450 can be powered using an AC/DC power convertor (supplied) or direct from a vehicle battery. When

powering the device from the mains power supply, always use the AC/DC convertor supplied with the unit and

NEVER connect directly to mains voltage. Doing so will invalidate the warranty of the device.

based applications. As such, it incorporates ignition based power switching. When the ignition is switched completely

off, the HD-IP450 will be powered down. To maintain power to the HD-IP450 while the vehicle is not running (engine is

off) the ignition key should be turned to the accessory (e.g. radio) position to maintain the +12V supply to the unit.

The ignition key should not be turned to the off position otherwise the HD-IP450 will begin powering down. For further

details on vehicle-based power connections, refer to Appendix B.

Connecting antennas for cellular and GPS connections

The front of the unit also includes antenna fixings for the internal modem (two antennas for 3G/4G cellular networks),

internal Wi-Fi module and GPS. Use antennas with screw fixings that are an appropriate form factor for the

deployment conditions. Antennas for each of these are supplied with the HD-IP450.

Default LAN port IP Addresses

For ease of deployment each LAN port on the HD-IP450 device is pre-configured with a static IP address:

LAN Port

USB to Ethernet

ISSUED: 10 NOVEMBER 2020

Default IP Address

192.168.10.1

LAN1

192.168.11.1

LAN2

192.168.12.1

LAN3

192.168.13.1

LAN4

192.168.14.1

The AC/DC power convertor (PSU) that is supplied with the

HD-IP450 can be used to power the unit from the mains.

An in-line switch on this power supply emulates

connection/disconnection of a vehicle ignition connection

(see left). This switches +12V to the ignition input of the

HD-IP450 device.

The HD-IP450 is specifically designed for use in vehicle-

Subnet mask

255.255.255.0

PAGE 6