Crestron FlipTop FT2-1200-ELEC-PTL Manuale di avvio rapido - Pagina 3

Sfoglia online o scarica il pdf Manuale di avvio rapido per Sistemi di controllo Crestron FlipTop FT2-1200-ELEC-PTL. Crestron FlipTop FT2-1200-ELEC-PTL 9. Cable management system, 1200 size, electrical, pass-through lid
Anche per Crestron FlipTop FT2-1200-ELEC-PTL: Come iniziare (2 pagine)

Stampa la pagina

FT2-1200-ELEC-PTL

FlipTop™ FT2 Series Cable Management System, 1200 Size, Electrical, Pass-Through Lid

4. Ensure that all four swiveling dogs are tucked inside of the FT2

assembly, and then insert the FT2 assembly into the mounting hole

until the top lip is flush with the table surface.

5. Carefully tighten the four swiveling dogs in each corner of the FlipTop

assembly clockwise until the FT2 assembly is secured in place against

the table. Do not overtighten the swiveling dogs.

CAUTION:

A screwdriver or manual torque screwdriver at its lowest

setting may be used to tighten the swiveling dogs. Avoid stripping

the swiveling dogs and damaging the table.

If removing the FT2-1200-ELEC-PTL from the table, ensure that

the screwdriver rotation is set correctly before loosening the

swiveling dogs.

Connect the FlipTop Assembly

Access the two network connectors and two power bus barrel jacks on

the underside of the FT2 assembly.

Connect the Network

Automate the one-touch retractors by connecting all retractors in an

FT2 assembly to a control system and a switch, or to a DMPS via a single

Cresnet® cable. Custom programming can trigger the retractors after

five minutes of no video detected.

Connect the FT2 assembly to a Crestron control system or DMPS3 via

the 3-pin connector using standard Cresnet cable. The red power lead is

not connected and should be terminated.

Quick Start