Accutone WT 89 Manuale di installazione e manuale d'uso - Pagina 5

Sfoglia online o scarica il pdf Manuale di installazione e manuale d'uso per Cuffie Accutone WT 89. Accutone WT 89 8. Wireless telephone headset

Stampa la pagina

B. INSTALLING YOUR WT89 HEADSET

Installation

B4. pairing the wireless headset with your telephone

Different telephones have different

settings, in some cases you will have to

adjust your wireless headset to pair with

your specific telephone.

To see whether your headset needs

adjustment, put on your headset (after it is

fully charged and properly connected),

press the Answer Button (5) on your

headset for the lifter to uplift the handset,

or manually pick up the handset if you

don't have a lifter.

If you hear a dial tone, the wireless headset works with your telephone. But if

you do not hear a dial tone, pair the two by sliding the Configuration Switches

(L) & (M) until you hear a dial tone.

putting everything together!

Now make a call using your telephone.

If the person on the other end hears you

perfectly, the pairing is completed.

If you hear the caller, but s/he cannot

hear you or the volume is very low, slide

the Configuration Switches (L) & (M),

until you find the best setting. Note that

out of the 12 possible combinations,

there may be more than one optimal

setting.

B5. adjusting signal amplification

In some cases, the default volume for the microphone or the speaker of the

telephone is not sufficient for the wireless headset. The WT89 allows extra

amplification for these cases.

On the bottom of the device, you find two small switches allowing four levels

of settings each for the Mic Amp Adjustment (N) and Speaker Amp

Adjustment (O). Follow the illustration above, and make the adjustments

corresponding the area you need to amplify. Level 4 gives the highest volume.

B6. re-registering headset with base unit

The WT89 headset and base unit comes pre-registered as a pair. But in case

the headset loses synchronization with the base, you can re-register it by:

1. Hold down the Page Button (D) of the base unit until it flashes blue

2. Remove the headset, press the Answer Button (5) until it also flashes blue

3. Press the Tone Decrease Button (F) of the base unit 3 times

4. The indicator on the base unit flashing blue slows down

5. Press the Answer Button (5) on the headset once

6. Indicator of the base unit flashes quicker, a click sound follows

7. Click sound indicates successful pairing, press Answer Button(5) to retest

[ inspiring people, inspiring change ]

Installation

Level 1

Level 2

Level 3

Level 4