Digital Control DigiTrak Falcon F1 Manuale di avvio rapido - Pagina 3

Sfoglia online o scarica il pdf Manuale di avvio rapido per Apparecchiature industriali Digital Control DigiTrak Falcon F1. Digital Control DigiTrak Falcon F1 6.

Stampa la pagina
c.
Position the Tx's infrared (IR) port near the locator's IR port.
Falcon locators with programmable power mode override
any other selection method when used with a V2 Tx.
d.
Tx Pairing
Select
appears (5 to 10 seconds) and the locator beeps.
e.
After a successful pairing, the locator displays the Down band with the
power mode.
f.
Click to confirm the power level. The 1 pt calibration menu opens.
3. Calibrate
Calibrate in an interference-free environment
after any pairing or Tx Power Mode change.
a.
Place the Tx in a housing on level ground and
measure 10 feet from the nearest edge of the
locator to the center of the transmitter.
b.
Continue
Select
the locator during calibration. The AGR screen opens.
c.
Check the default Above Ground Range (AGR) with a tape measure to
verify depth readings on each band at least two depths (5 ft and 15 ft).
Distance readings should be within ±5%. Select
If the roll indicator on the Locate Mode screen displays a triangle error symbol
that band has not been calibrated. Go to the Calibration menu and complete a 1
pt calibration for that band.

Settings Menu

Use the Settings menu
telemetry channel, Target Steering depth, leveling, LOC security settings,
contrast, and Cal history. Set the remote display to match locator settings.
Height-Above-Ground (HAG) Menu
Height-Above-Ground (HAG) is the distance from the ground to the
bottom of the locator while it is held or on a TrakStand. Enabling HAG
on the Main menu lets you take accurate below-ground depth
measurements without having to place the locator on the ground.
Target Steering assumes the locator is on the ground unless TrakStand HAG is
enabled. For more information, search the DCI DigiGuide App for "Target
Steering" and "TrakStand."
and hold the Tx in place until the check mark
to calibrate. Do NOT move
to set the depth units, pitch units, roll offset,
Exit
.
- 3 -