Digital deep sea 4GXtream Manuale del prodotto - Pagina 5

Sfoglia online o scarica il pdf Manuale del prodotto per Attrezzatura marina Digital deep sea 4GXtream. Digital deep sea 4GXtream 13. 3g/4g router

3.4

Power Requirements

The unit is designed to work on vessels with a 12V or 24V DC system (9-30V DC Input voltage). It should be wired to a 1

Amp fused or circuit breaker protected circuit and if connected to a higher amperage circuit, then a 1A in-line fuse should

be used to protect the 4GXtream wiring.

The 4GXtream has a two-core power cable with a Red (+) and Black (-) wire. Be very careful to ensure that the correct

supply voltage polarity is connected to the 4GXtream, as reverse polarity will damage the unit.

Once connected to the vessel's 12v/24v DC system, do not apply power but continue with the installation steps below.

3.5

Network Connections

The 3GConnect has four RJ45 Ethernet connectors; 3x LAN and 1x WAN.

If you wish to connect additional wired devices to the 4GXtream's local area network (LAN) such as a Smart TV, fixed

mount computer, VOIP Phone, etc. then use a conventional network cable to connect the devices to any of the 3x LAN

sockets of the 4GXtream.

If you wish to connect an Ethernet based long range wireless adaptor, such as the Digital Yacht WL510, so that you can

access wireless hotspots in bars, marinas, etc. then connect the adaptor using a normal network cable to the 4GXtream's

WAN socket. The 4GXtream expects to receive an IP address automatically from the long-range wireless adaptor.

Whether the 4GXtream uses its mobile connection or wired WAN connection to access the internet, can be selected in

the units web interface, which is covered later in this manual.

3.6

Inserting a 3G/4G data SIM card

To connect to the internet, the 4GXtream must have a 3G/4G data SIM inserted which is registered to a valid mobile

operator account. Any mobile operator's SIM can be used that is the Standard SIM (15 x 25mm) size.

The 4GXtream has two standard SIM slots and it is possible to fit two SIMs from two different network operators. You can

set SIM switching rules to decide which SIM is given preference i.e. No network, weak signal, data limit reached, etc.

To insert a SIM (Fig 2), remove the SIM extractor tool (1) and gently press the end of the tool into the hole to the right of

the SIM tray you wish to use. The tray will partially eject and you can then pull the SIM tray out completely. Place the SIM,

gold contacts up, into the tray. Finally re-insert the SIM tray making sure that it is correctly lined up with the slot and goes

in straight/perpendicular and not at an angle. Don't forget to replace the SIM extractor tool back into its slot for future use.

Figure 4

TEL + 44 1179 554474 www.digitalyacht.co.uk

Product Handbook for 4GXtream V1.00