DIGITAL DELAY Elite 95 Manuale - Pagina 10

Sfoglia online o scarica il pdf Manuale per Unità di controllo DIGITAL DELAY Elite 95. DIGITAL DELAY Elite 95 11.

Explanation of the Starting Line Enhancer

The diagram below is to help understand how the Starting Line Enhancer works. When turned on, the Starting Line

Enhancer will close the throttle while the vehicle is being staged. This can be done two different ways, first, if a Tap Push-

button is pressed before a Transbrake Push-button is pressed the throttle will close, and second, when the Transbrake Push-

button is pressed the throttle will close. Once the Starting Line Enhancer is engaged the driver can then fully press the gas

pedal. The throttle stop limits the engine RPM to a preset amount. After the throttle has been closed the Starting Line

Enhancer will open the throttle at the programmed amount of time before or when the Transbrake solenoid is released.

Setting the

Press the 4 key, to bring up the Starting Line Enhancer setting. The number shown on the right screen represents the

mode the Starting Line Enhancer is in. If 1 thru 5 is displayed the Starting Line Enhancer is turned on, if a 6 is displayed, the

Starting Line Enhancer is turned off. The list below shows what each mode number means.

Using Mode 1 will release the SLE 8 tenths of a second before the Transbrake releases.

Using Mode 2 will release the SLE when the Transbrake releases.

Using Mode 3 will release the SLE when the Transbrake Push-button is released.

Using Mode 4 will release the SLE when the Transbrake Push-button is engaged. (This is used in pro light racing)

Using Mode 5 will release the SLE one second before the Transbrake releases.

Using Mode 6 will turn off the SLE.

To change the Starting Line Enhancer mode, first use the 2ND key to move the selection arrows to the right side of

the screen. Then use the Up or Down arrow keys to change the Starting Line Enhancer mode to the desired number.

The Elite 95 uses the Throttle Mode setting to control whether the output on the terminal strip for the Starting Line

Enhancer is putting out 12 volts or taking 12 volts away when activated. To change the output voltage setting follow the

instructions for Setting the Throttle Mode on page 9.

Starting Line Enhancer Mode

Starting Line Enhancer = 00.40

Crossover Delay = 01.35

Timer 1

Timer 2

Timer 3

Timer 4

= 1.000

= 2.000

= 08.00

= 00.50