Digital Electronics Corporation APL3700-TD Manuale di installazione - Pagina 13

Sfoglia online o scarica il pdf Manuale di installazione per PC industriale Digital Electronics Corporation APL3700-TD. Digital Electronics Corporation APL3700-TD 17.

Stampa la pagina

• Accompanying power supply connector is

a CA7-ACCNL-01 of Pro-face or FKC2,5/

3-STF-5,08 of Phoenix Contact.

Connecting the Power Cord

(1) Confirm that the power is not supplied to

the PL unit.

(2) Push the Opening button by a small and flat

screw driver to open the desired pin hole.

(3) Insert each pin terminal into its each

hole. Release the Opening button to

clamp the pin place.

AC power supply cable

Black

Green/Yellow

(4) After inserting all three pins, insert the

Power Plug into the Power Connector at PL.

Fix the plug with two minus screws.

• Confirm that all wires are connected

correctly.

• The torque required to tighten these

screws is 0.5 to 0.6 N•m [5-7Lb•In].

• To prevent the possibility of a terminal

short, use a pin terminal that has an

insulating sleeve.

Wiring the DC type power supply cable

• When the FG terminal is connected, be

sure the wire is grounded. Not ground-

ing the PL unit will result in excessive

noise. Use your country's applicable

standard for grounding.

Opening button

White

Power Cord Specifications

Use copper conductors only.

Power Cord

Diameter

Conductor Type Simple or Stranded Wire

Conductor

Length

*1 If the Conductor's end (individual) wires are not

twisted correctly, the end wires may either short

against each other, or against an electrode.

Power Connector (Plug) Specifications

−

Insertion Direction

• Accompanying power supply connector is CA5-

DCCNL-01 of Pro-face or GMVSTBW2.5-3-

STF-7.62 of Phoenix Contact.

When connecting the power code, use the

following items when performing wiring. (Items

are made by Phoenix Contact.)

Recommended

Driver

Recommended

Pin Terminals

Recommended

Pin Terminal

Crimp Tool

Connecting the PL Power Cord

(1) Confirm that the power is not supplied to

the PL unit.

(2) Loosen three screws in the center of the

Power Connector (plug).

0.75 to 2.5mm

(18 - 12 AWG)

7mm [0.28in]

SZF 1-0.6x3.5

(1204517)

AI 0.75-8GY (3200519)

AI 1-8RD (3200030)

AI 1.5-8BK (3200043)

AI 2.5-8BU (3200522)

CRIMPFOX ZA 3

(1201882)

24V

Grounding

Terminal

connected

to the PL

chassis