Digital Equipment Prioris Series Manuale di installazione - Pagina 8

Sfoglia online o scarica il pdf Manuale di installazione per Server Digital Equipment Prioris Series. Digital Equipment Prioris Series 15.
Anche per Digital Equipment Prioris Series: Manuale (16 pagine)

Stampa la pagina

If you're installing optional expansion cards

Make sure you are familiar with using:

The System Configuration Utility (SCU)

The SCSISelect Utility

Refer to your System Reference and SCSI manuals for any

additional information.

ISA cards should be installed after you run the following Sys-

tem Configuration Utility since the SCU will list IRQs already

used. PCI cards should be installed before running the SCU to

take advantage of the SCU's automatic detection feature.

Run the SCU

Use the Quick Launch CD-ROM disk to complete the server

installation. Follow these steps to configure your server.

NOTE

The following is not applicable for Prioris XLe 6000 Series

Servers that do not have a bootable CD-ROM drive installed.

Instead, take the Quick Launch CD-ROM to any other Win-

dows based personal computer with a CD-ROM drive. Create a

bootable SCU diskette by running the Quick Launch Program.

1. Locate the Quick Launch CD-ROM disk in your Server-

WORKS software kit. Power on your server and insert

the CD-ROM disk. Press Ctrl + Alt + Del to reboot your

server.

If your server fails to boot from the CD-ROM, press Ctrl

+ Alt + Del again, then Ctrl + A, when prompted, to

run the SCSISelect utility. Enable the Bootable CD-ROM

and INT13 lines, exit and reboot.

2. Select your language and hold the Alt key until the

SCU starts automatically.

3. Use the SCU, when displayed, to enable the PCI cards.

Install ISA cards if desired

If you are installing ISA cards, check the current card con-

figuration to avoid IRQ conflicts before manually setting

jumpers and switches. After installing the cards, run the

SCU again and check the card configuration.

Your server automatically reboots after you save and exit

the SCU.

NOTE

If you installed additional SCSI cards, make sure the MS-

DOS partition resides on the bootable drive. If not, shut

down your server, change the order of your cards and

reconfigure your server.

Prioris Servers