Digital Equipment TLZ07 Manuale di installazione - Pagina 7

Sfoglia online o scarica il pdf Manuale di installazione per Immagazzinamento Digital Equipment TLZ07. Digital Equipment TLZ07 16. Tape drive for dec 4000 model 6x0/7x0 axp series

Stampa la pagina

Installation

Static electricity can damage integrated circuits. Use the antistatic

wrist strap and antistatic pad found in the static-protective kit (ON

29–26246–00) when you work with the internal parts of a computer

system.

Before you begin the installation procedure, remove the bus continuity card

from the option storage slot into which you intend to install the tape drive.

Figure 6 shows the location of the bus continuity cards.

To install a TLZ07-MX tape drive in your system, perform the following steps:

1. Slide the TLZ07-MX mounting bracket assembly into the option storage

slot and push until the connector on the SCSI paddle card on the drive

mounting bracket engages securely into the backplane. Secure the

assembly by tightening the two captive screws. Figure 2 shows the location

of one of the screws. The second screw is located on the bottom drive

mounting bracket. Do not over-tighten the screws; 9" lbs is sufﬁcient to

secure the drive. It is normal for there to be a slight gap between the

bracket and chassis.

2. Attach the SCSI ID cable to the OCP connector on the bezel assembly

(Figure 2).

3. Insert the tabs on the bottom of the bezel into the slots on the storage slot

(Figure 2).

4. Push in the top of the bezel, and tighten the Phillips screw (Figure 2).

5. Install a SCSI ID plug to the front of the bezel, making sure that the SCSI

ID number is not used by another device. The bezel is marked to show the

corresponding SCSI ID plug for each slot.

To add a TLZ07-MY tape drive to your system, perform the following steps:

1. Remove the mounting assembly as follows:

•

Remove any SCSI ID plugs installed in the bezel.

•

Loosen the Phillips screw at the top of the bezel, pull out the top of the

bezel, and carefully lift the bezel up and out from the storage slot to

expose the SCSI ID cables.

Caution

TLZ07