Siemens SIMATIC ET 200AL Manuale dell'apparecchiatura - Pagina 26

Sfoglia online o scarica il pdf Manuale dell'apparecchiatura per Apparecchiature industriali Siemens SIMATIC ET 200AL. Siemens SIMATIC ET 200AL 27. 10-link digital output module dq 8x24vdc/2a 8xm12
Anche per Siemens SIMATIC ET 200AL: Manuale (38 pagine), Manuale (50 pagine), Manuale (38 pagine), Manuale (32 pagine), Manuale (37 pagine), Manuale dell'apparecchiatura (46 pagine), Manuale (26 pagine), Manuale dell'apparecchiatura (28 pagine), Manuale (25 pagine)

Stampa la pagina

Siemens SIMATIC ET 200AL Manuale dell'apparecchiatura

7.2

Behavior of the digital input module

Display

The channel status LEDs are directly influenced by the signal level at the socket.

If the encoder supply is switched off, this causes the channel status LEDs to also switch off.

Response to error detection

All channels that are in pause mode on "PE_MODE_PROCEED" report their diagnostic status as

in productive mode.

The following applies for all channels which switch to a different pause mode:

• Encoder supply switch-off upon the start of "pause" does not result in the "Short-circuit"

alarms.

• During the "pause", error detection of "Short circuit" is not possible:

– Alarms for errors already pending before the "pause" are retained.

– After the "pause" is over, the error status is updated and incoming/outgoing errors are

Mode parameter

The following table shows the "Mode" parameter.

Table 7- 1

Element Code

Mode

As there is only one encoder supply U

"pause" if no channel is configured in PE_MODE_PROCEED.

DI 8x24VDC 4xM12 (6ES7141-5AF00-0BA0)

Equipment Manual, 08/2021, A5E36680963-AB

reported correspondingly.

Mode parameter

: PE_MODE_PROCEED

: PE_MODE_SHUTDOWN

: PE_MODE_LAST_VALUE

: PE_MODE_SUBST_VALUE

7.2 Behavior of the digital input module

Explanation

Proceed at "pause"

•

Value status "GOOD"

Switch off at "pause"

•

Encoder supply U

•

Pause substitute value: 0

•

Value status "BAD"

Last value at "pause"

•

Encoder supply U

•

Pause substitute value: Last input value

•

Value status "BAD"

Substitute value at "pause"

•

Encoder supply U

•

Pause substitute value: Configured pause substi-

tute value

•

Value status "BAD"

for all channels, the supply can only be switched off at

PROFIenergy

switched off