Siemens simatic ET 200MP Manuale - Pagina 12

Sfoglia online o scarica il pdf Manuale per Apparecchiature industriali Siemens simatic ET 200MP. Siemens simatic ET 200MP 29. Digital output module dq 16x230vac/2a st relais (6es7522-5hh00-0ab0)
Anche per Siemens simatic ET 200MP: Manuale (40 pagine), Manuale (24 pagine), Manuale (47 pagine), Manuale (26 pagine), Manuale (28 pagine), Manuale (50 pagine), Manuale (34 pagine), Manuale d'uso (44 pagine), Manuale (30 pagine), Manuale (25 pagine), Manuale (42 pagine), Manuale (28 pagine), Manuale (33 pagine), Manuale (49 pagine), Manuale (36 pagine), Manuale (39 pagine), Manuale (28 pagine), Manuale dell'apparecchiatura (35 pagine), Manuale dell'apparecchiatura (32 pagine), Manuale (29 pagine), Manuale (34 pagine), Manuale (36 pagine), Manuale dell'apparecchiatura (50 pagine), Manuale (45 pagine)

Stampa la pagina
Siemens simatic ET 200MP Manuale
Product overview

2.2 Functions

2.2
Functions
PROFINET IO
The interface module supports the following PROFINET IO functions:
● Integrated switch with 2 ports
● Supported Ethernet services: ping, arp, network diagnostics (SNMP)/MIB-2, LLDP
● Port diagnostics
● Disabling ports
● Minimum update time 1 ms
● Device replacement without programming device
● Media redundancy (MRP)
● Shared device with two IO Controllers
● Module-internal Shared Input/Shared Output (MSI/MSO)
● Identification data I&M 0 to 3
● Firmware update via PROFINET IO
● Reset to factory settings via PROFINET IO
● Module division into submodules
Requirements
The following requirements apply for the usage of the PROFINET IO functions with the
IM 155-5 PN BA interface module:
You use the following as the design software:
● STEP 7 (TIA Portal) as of V14 with HSP 0187
● With GSD file: The usability of the PROFINET IO functions depends on the configuration
software (Siemens and/or third party). Below, the usability of the PROFINET IO functions
is described for STEP 7 only.
– STEP 7 as of V5.5 SP3
– STEP 7 (TIA Portal V13 or higher)
The GSD file can be found on the Internet
(https://support.industry.siemens.com/cs/ww/en/view/68189683).
Cabling with fixed connection setting
If you set a fixed connection setting of the port in STEP 7, you should also deactivate
"Autonegotiation/Autocrossover".
You can find additional information in the STEP 7 online help and
● as of STEP 7 V14, in the PROFINET with STEP 7 V14
(https://support.industry.siemens.com/cs/ww/en/view/49948856) function manual.
12
Interface module IM 155-5 PN BA (6ES7155-5AA00-0AA0)
Manual, 02/2017, A5E38017683-AA