Epson XP-4105 Manuale di avvio rapido - Pagina 2

Sfoglia online o scarica il pdf Manuale di avvio rapido per Stampante Epson XP-4105. Epson XP-4105 4.
Anche per Epson XP-4105: Manuale rapido (17 pagine)

Stampa la pagina
Epson XP-4105 Manuale di avvio rapido
2
Gently shake the black ink cartridge.
Note:
Do not shake the other ink cartridges.
3
Unpack the ink cartridges.
4
Remove only the yellow tape from each ink cartridge.
Caution:
Do not remove any other labels or seals, or ink will
leak. Do not touch the green chip on the cartridge.
5
Insert the cartridge in the holder for each color. Press each
cartridge down until it clicks. Make sure all cartridges are
pushed down into place.
6
Lift the scanner unit up slightly and lower it. When
the scanner unit catches, lift it up again and lower it
completely.
7
Press OK to start charging the ink delivery system.
8
The printer starts charging the ink. Ink charging takes
approximately 6 minutes. When you see a completion
message on the printer's LCD screen, charging is
complete.
Caution:
Don't turn off the printer or raise the scanner unit while
it is charging or you'll waste ink.
Note:
As part of setup, your product's serial number will be sent
to a secure Epson server so that you can be eligible to participate
in programs we may offer from time to time, including the Epson
ink replenishment program. You will have a separate opportunity
to consent to participating in such programs.
9
Follow the on-screen instructions to adjust the print
quality of your product.
Note:
• You need to load paper before you can adjust the print quality.
See "Load paper" below for details.
• Select Adjust Later if you want to adjust the print quality later.
For more information, see the online User's Guide.
4
Load paper
See the online User's Guide for information about loading
capacity, available paper types and sizes, and loading
envelopes.
1
Make sure the product is not charging. Then flip the
feeder guard forward, raise the paper support, and tilt it
backwards slightly.
2
Slide the edge guides all the way out.
3
Load paper, glossy or printable side up and short edge
first, in the middle of the rear paper feed slot.
4
Slide the edge guides against the paper, but not too
tightly.
5
Pull out the output tray.
6
Follow the instructions on the LCD screen to select your
paper settings.