Siemens SIMATIC RTLS Manuale di istruzioni per l'uso - Pagina 19

Sfoglia online o scarica il pdf Manuale di istruzioni per l'uso per Apparecchiature industriali Siemens SIMATIC RTLS. Siemens SIMATIC RTLS 21. Localization systems
Anche per Siemens SIMATIC RTLS: Manuale del dispositivo (14 pagine), Manuale di istruzioni per l'uso (20 pagine), Manuale di istruzioni per l'uso (21 pagine), Manuale di istruzioni per l'uso (30 pagine)

Article 3 (2) Efficient use of the radio spectrum

● ETSI EN 300 328

Wideband transmission systems; Data transmission equipment operating in the 2.4 GHz

ISM band and using wide band modulation techniques. Harmonized standard covering

the essential requirements of article 3.2 of the EU Directive 2014/53/EU

● ETSI EN 302 065-2

Short Range Devices (SRD) using ultra-wideband technology (UWB); Harmonized

standard covering the essential requirements of article 3.2 of the Directive 2014/53/EU;

Part 2: Requirements for UWB location tracking

Note

The specified approvals are only valid if the corresponding symbol is printed on the

device.

FCC information

Siemens SIMATIC RTLS PCB OEM AC (6GT2700-8DF10-0AX1); FCC ID NXWOEMAC

This device complies with part 15 of the FCC rules. Operation is subject to the following two

conditions:

(1) This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause

undesired operation.

Caution

Any changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment.

Note

This equipment has been tested and found to comply with the limits for a Class A digital

device, pursuant to part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference

when the equipment is operated in a commercial environment. This equipment generates,

uses, and can radiate radio frequency energy and, if not installed and used in accordance

with the instruction manual, may cause harmful interference to radio communications.

Operation of this equipment in a residential area is likely to cause harmful interference in

which case the user will be required to correct the interference at his own expense.

Host labelling guidance for the end integrator

This is an advise for host manufacture to provide a physical / e-label on their host product

stating, "Contains FCC ID: NXWOEMAC":

A permanently affixed label must be used. The modular transmitter must be labeled with its

own FCC identification number, and, if the FCC identification number is not visible when the

module is installed inside another device, then the outside of the device into which the

module is installed must also display a label referring to the enclosed module. This exterior

SIMATIC RTLS PCB OEM AC

Operating Instructions, 03/2020, C79000-G8976-C519-03

Approvals