Siemens SINAMICS G130 Manuale di istruzioni per l'uso - Pagina 15

Setting parameters with the BOP20

4.1

Overview of displays/indicators and keys

Figure 4-1

Table 4- 1

Displays/indicators

Display

Top left, 2 chars.

RUN

Top right, 2 chars.

Bottom, 6 chars.

Basic Operator Panel 20 (BOP20)

Operating Instructions, 03/2013, A5E00809375A

Overview of displays/indicators and keys

The active drive object of the BOP is displayed here.

The displays and key operations always refer to this drive object.

Lit if at least one drive in the drive line-up is in the RUN state (in operation).

RUN is also displayed via bit r0899.2 of the drive.

The following is displayed in this field:

More than 6 digits: Characters that are present but cannot be seen (e.g. "r2" ––>



2 characters to the right are invisible, "L1" ––> 1 character to the left is invisible)

Faults: Selects/displays other drives with faults



Designation of BICO inputs (bi, ci)



Designation of BICO outputs (bo, co)



Source object of a BICO interconnection to a drive object other than the active one.



Lit if at least one parameter was changed and the value was not transferred to the non-

volatile memory.

Lit if the parameter value does not become effective until the P key is pressed.

Lit if at least one parameter was changed and the calculation for consistent data

management has still not been initiated.

Displays parameters, indices, faults, and alarms.

Meaning