Epson 520 Impostazione rapida - Pagina 2
Sfoglia online o scarica il pdf Impostazione rapida per Proiettore Epson 520. Epson 520 4. Data projector epson powerlite 520/525w/530/535w
Anche per Epson 520: Manuale operativo (36 pagine), Impostazione rapida (4 pagine)
Stampa la pagina
Adjust the image
1
If you don't see an image, press the Source Search button on the
projector or the remote control to select the image source.
Note: If you still see a blank screen or have other display problems, see
the troubleshooting tips on the back of this sheet.
2
To raise the image, press the foot release button and lift the front of the
projector. Release the button to lock the foot in position.
3
Press the Wide or Tele buttons on the projector to reduce or enlarge the
image.
4
Turn the focus ring to sharpen the image.
5
If your image looks like
off to one side of the screen at an angle. Place the projector directly in
front of the center of the screen, facing the screen squarely. If you
can't move the projector, press the
open the keystone correction menu then use the Wide or Tele buttons to
correct the image.
6
If your image looks like
button on the projector to correct it.
or
, you may have placed the projector
or
button on the projector to
or
, you can press the
or
Using the remote control
Make sure the batteries are installed as shown (two AA batteries).
Turn projector
on and off
Access projector
menus
Turn off projector
display
For more information on using the remote control, see the online User's
Guide.
Project wirelessly from a
computer
Follow the steps here to connect the projector over a wireless network. You
will need the optional wireless LAN module (part number V12H418P12).
1
To install the optional wireless LAN module, first remove the screw as
shown.
2
Connect the wireless LAN module to the USB-A (flat) port.
3
To configure your projector for wireless projection, do one of the
following:
•
If you're using the optional Quick Wireless Connection USB key
(Windows only, part number V12H005M09), press the LAN button on
the remote control. When you see SSID and IP address information
on the screen, remove the wireless LAN module and connect the
key to the projector's USB-A port. Look for the displayed message,
remove the key, and connect it to a USB port on your computer.
Follow your computer's on-screen instructions to install the driver,
then reconnect the wireless LAN module to the projector's USB-A
port. For details, see the online User's Guide.
•
If you're not using the key, continue with step 4.
Choose which
source to display
Switch between computer and
interactive pen
Navigate projector
menus
Get solutions to
common problems