ActronAir Cascade 2 CRE-100CS Manuale d'uso - Pagina 11

Sfoglia online o scarica il pdf Manuale d'uso per Manipolatori d'aria ActronAir Cascade 2 CRE-100CS. ActronAir Cascade 2 CRE-100CS 16. Four way cassette

Stampa la pagina
Owner's Manual
When troubles occur, please check the following points before contacting a HVAC service repair company.
Fault
The unit is not working
Poor Cooling / Heating
Performance
The unit starts and stops
frequently
NOTE
If your problem persists after performing the checks and diagnostics above, turn off your unit immediately and contact
ActronAir on 1800 119 229 for technical support or warranty.

08. Display / Error Codes

When troubles occur, please check the following points before contacting a qualified service technician.
Normal Display (not error code)
Display
Operation
Codes
Lamp
dF
-
CL
-
CL
-
nF
-
FP
-
FC
-
AP
-
CP
-
Possible Causes
Power failure
The power switch is off
Remote control batteries are dead
The unit's 3-minute protection has been
activated
Temperature setting may be higher than
the ambient room temperature for the
cooling mode; or lower than the ambient
temperature for the heating mode
The heat exchanger on the indoor or
outdoor unit is dirty
The air filter is dirty
The air inlet or outlet of either unit is
blocked
Doors and windows are open
Excessive heat is generated by sunlight
(Cooling only)
Setpoint is reached
Unit encounters an error
Timer Lamp
-
Defrost
-
Filter cleaning reminder (power on display for 15 seconds)
-
Active clean
-
Filter replacement reminder (power on display for 15 seconds)
-
Heating in room temperature under 8°C
-
Forced cooling
-
AP mode of WIFI connection
-
Remote switched off
Owner's Manual - Cascade Series 2
Doc. No. 9590-4016 Ver. 2 220616
Four-Way Cassette
Remedies
Wait for the power to be restored
Turn on the power
Replace the remote control batteries
Wait three minutes after restarting the unit
Adjust to temperature setting higher / lower
Clean the affected heat exchanger
Remove the filter and clean it according to
instructions
Turn the unit off, remove the obstruction and
turn it back on
Make sure that all doors and windows are
closed while operating the unit
Close windows and curtains during periods of
high heat or bright sunshine
Check that the setpoint is not reached
Check that the unit does not display any error
Causes
11