Siemens SN23E832TI Manuale di istruzioni per l'uso - Pagina 38
Sfoglia online o scarica il pdf Manuale di istruzioni per l'uso per Lavastoviglie Siemens SN23E832TI. Siemens SN23E832TI 42.
en
Installation and connection
Drinking water connection
1. Fasten the drinking water connection
to the tap according
to the installation instructions using
the enclosed parts.
Ensure that the drinking water
connection is not kinked, crushed
or twisted.
2. When replacing the appliance,
always use a new water supply hose.
Water pressure:
At least 0.05 MPa (0.5 bar), maximum
1 MPa (10 bar). At a higher water
pressure: connect pressure-reducing
valve ahead.
Inlet rate:
Minimum 10 litres/minute
Water temperature:
Note printing on the water inlet hose!
If models are marked with 25°,
the water temperature may be max.
25 °C (cold water).
For all other models:
Cold water preferred; hot water max.
temperature 60 °C.
38
Warm water connection *
* depending on model
The dishwasher can be connected
to cold or hot water up to max. 60 °C.
Connection to hot water
is recommended if the hot water can be
supplied by energetically favourable
means and from a suitable installation,
e. g. solar heating system with
circulation line.
This will save energy and time.
The hot water setting :
to adjust your appliance optimally
to operation with hot water.
It is recommended to have a water
temperature (temperature of the
incoming water) of at least 40 °C
and no more than 60 °C.
It is not recommended to connect
the appliance to hot water if the water
is supplied from an electric boiler.
Setting hot water:
1. Close the door.
2. Switch on ON/OFF switch (.
3. Press and hold down the START
button @.
4. Rotate programme selector 8
until :
is indicated on the digital
display H.
5. Release button.
The factory-set value :
the digital display H.
To change the setting:
1. By rotating the programme
selector 8, you can switch the hot
water setting off :
2. Press START button @.
The set value is saved.
W a r m w a t e r c o n n e c t i o n
allows you
is lit on
or on :
.