Siemens EC945RB90A Istruzioni per l'utente - Pagina 7

Sfoglia online o scarica il pdf Istruzioni per l'utente per Piano cottura Siemens EC945RB90A. Siemens EC945RB90A 12. Maintenance instructions

Stampa la pagina

Warnings concerning cooking:

DON'Ts
Do not use small recepta-
cles on large burners. The
flame should not touch the
sides of receptacles.
Do not cook without lids or
Do not cook without lids or
with lids only partially cove-
with lids only partially cove-
ring receptacles. You are
ring receptacles. You are
wasting energy.
Do not use receptacles with
Do not use receptacles with
Do not use receptacles with
uneven bases. They leng-
uneven bases. They leng-
uneven bases. They leng-
then cooking times and in-
then cooking times and in-
then cooking times and in-
crease energy consumption.
Do not place receptacles on
Do not place receptacles on
Do not place receptacles on
burners off centre. They
burners off centre. They
burners off centre. They
could tip over.
Do not use wide-based re-
Do not use wide-based re-
Do not use wide-based re-
ceptacles on the burners
ceptacles on the burners
ceptacles on the burners
nearest to the controls.
nearest to the controls.
nearest to the controls.
When centred on the bur-
When centred on the bur-
When centred on the bur-
ner, they could touch the
ner, they could touch the
ner, they could touch the
controls or raise the tempe-
controls or raise the tempe-
controls or raise the tempe-
rature in the area. This may
rature in the area. This may
rature in the area. This may
damage the hob.
Do not place receptacles
Do not place receptacles
Do not place receptacles
directly on top of burners.
directly on top of burners.
directly on top of burners.
Do not use excessive weig-
Do not use excessive weig-
hts or strike the hob with
hts or strike the hob with
heavy objects.
Do not use two burners or
heat sources for a single
recipient.
Do not use baking trays,
earthenware dishes, etc...
at full heat for a long time
17
DOs
Always use suitably sized
receptacles on each bur-
ner. This helps avoid ex-
cessive gas consumption
and prevents receptacles
from getting tarnished.
Always use lids.
Only use thick-,flat-based
saucepans,
frying pans
and casseroles.
Always place recepta-
cles
in the middle of
burners.
Always place receptacle
on the pans support.
Make sure that the metal
grids and the tops of the
burners are correctly posi-
tioned before using them.
Handle receptacles on the
hob with
care .
Only use one recipient per
burner. Use the extra
metal grid on the wok
burner.
.

Installation

Statutory
This installation must conform with the following:
requirements
• Manufacturer's Installation instructions
• Local Gas Fitting Regulations
• Municipal Building Codes,
• AGA Installation Code for Gas Burning Appliances.
(AS 5601 - 2004 - Gas Installations).
• S.A.A. Wiring Code
• Local Electrical Regulations
• Any other statutory regulations
Refer to the AGA Installation Code for piping size details.
Preparing to
These built-in hobs are intended to be inserted in a
install
benchtop cutout.
Only an officially authorised technician should connect
the appliance.
Before you begin, turn off the gas and electricity supply.
Installation dimensions are shown in Fig.1-1a.
Universal LPG
Natural gas
Pressure
test point.
Pressure
test point
Gas inlet
connection
1
Before connecting the unit, check whether the local
connection conditions (type of gas) are compatible with
the unit's setting. Observe any special conditions imposed
by local suppliers (utilities). The specifications of this
cooktop are stated on the data label located on the
bottom of the cooktop base.
A duplicate data label is supplied for adhesion to
an accessible location near the hotplate if the data
label on the base of the hotplate cannot be
accessed when the hotplate is installed.
Universal LPG
Natural gas
Pressure
test point.
Pressure
test point
Gas inlet
connection
1a
6