Siemens EF6 HNA Series Manuale di istruzioni - Pagina 10
Sfoglia online o scarica il pdf Manuale di istruzioni per Piano cottura Siemens EF6 HNA Series. Siemens EF6 HNA Series 16.
Anche per Siemens EF6 HNA Series: Manuale d'uso (16 pagine)
Stampa la pagina
Trouble shooting
en
3Trouble shooting
F aults often have simple explanations. Please read the
T r o u b l e s h o o t i n g
notes in the table before calling customer service.
Your hob's electronics are located underneath the
control panel. For various reasons, the temperature in
this area may rise sharply.
Display
Fault
None
The power supply has been disconnected.
All displays flash
The touch controls are wet or an object is rest-
ing on them.
The hotplate is locked and the hotplate switch
‹
flashes when
is on, e.g. after the timer has switched off or
switched on
after a power failure.
The data link between the cooker and hob is
"‹
malfunctioning.
Several hotplates have been used over a pro-
"ƒ
longed period at high power settings. To pro-
tect the electronics, the hotplate has been
switched off.
"...
Despite being switched off by
tronics have become hot again. All hotplates
have therefore been switched off.
Warning: There is a hot pan near the control
"†
and the heat set-
panel. There is a risk that the electronics will
ting flash alternately. A
overheat.
signal tone can be
heard
There is a hot pan near the control panel. To
"†
and signal tone
protect the electronics, the hotplate has been
switched off.
The hotplate was in operation for too long and
"‰
has switched itself off.
Demo mode is switched on
š"
The hotplates do
not heat up
E-report in the displays
When an error message with "E" appears in the display,
e.g. E0111, switch the appliance off and on again.
If it was a one-off error, the display goes out. If the error
message appears again, call the after-sales service and
quote the exact error message.
A
flashes in the hotplate indicators
If
flashes in the hotplate indicators when the
A
appliance is connected to the mains or following a
power cut, the electronics are malfunctioning. To
acknowledge the fault, briefly cover the controls with
your hand.
10
To prevent the electronics from overheating, the
hotplates are switched off when necessary. The
or
"†
indicator
Remedy
Check the household fuse for the appliance. Check whether there is a
power cut by trying other electronic appliances.
Dry the controls or remove the object.
Switch off the appliance. Switch the appliance back on.
Switch the appliance off and back on again after about 30 seconds, using
either the household fuse or the circuit breaker in the fuse box. Contact
customer service if this display appears again.
Wait a while.Touch any control. When
cooled down sufficiently. You can continue cooking.
"ƒ
, the elec-
Wait a while.Touch any control. When
cooking.
Remove the pan.The fault code will go out shortly afterwards. You can con-
tinue cooking.
Remove the pan.Wait a while. Touch any control.When
can continue cooking.
You can switch the hotplate back on again immediately.
Switching off demo mode: Disconnect the appliance for 30 seconds from
the power supply (switch off the household fuse or the circuit breaker in
the fuse box). Touch any control within the next 3 minutes. Demo mode is
switched off.
display appears alternately with the residual heat
or
.
•
œ
"ƒ
"...
"ƒ
,
"...
goes out, the electronics have
goes out, you can continue
"†
goes out, you