DIGITAL LAB DLCR606 Manuale di istruzioni - Pagina 3

Sfoglia online o scarica il pdf Manuale di istruzioni per Radio sveglia DIGITAL LAB DLCR606. DIGITAL LAB DLCR606 4.

5. Press the + or – Button to adjust the minute.

6. Press the AL1 Button for confirmation.

7. Press the AL1 Button for selection of how you want to be awakened.

A red LED lights up at Bell symbol means a buzzer sounds when the alarm time

is reached.

A red LED lights up at Music Note symbol means the radio will be switched on at

the last set station when the alarm time is reached.

8. You can turn off the alarm by pressing the AL1 Button repeatedly until no LED lights up

at the symbols.

Note: you can set the ALARM 2 by repeating the above steps with the AL2 Button.

TO REVIEW THE ALARM

1. After the alarm has been set, you can review the alarm time by pressing and holding the

AL1 or AL2 button for 2 seconds. The alarm time will be blinked on the display.

2. After 5 seconds, it will go back to normal time display.

TO STOP THE ALARM AND RESET THE ALARM READY FOR THE NEXT DAY

1. When the alarm goes off, press the ON/OFF button to stop the alarm.

2. The alarm will be automatically reset and gets ready for the next day.

SNOOZE FUNCTION

1. Press the SNOOZE button after an alarm goes off. The alarm will be silenced for 9

minutes and then sound again.

2. SNOOZE button can be pressed for 6 times. Then the alarm will be stopped

automatically and gets ready for the next day.

LISTENING TO THE RADIO

TO TUNE THE RADIO TO DESIRED STATION MANUALLY

1. Press the ON/OFF button to turn on the radio.

2. Press and hold the Tune/Volume button for approximate 2 seconds to select AM of FM

band.

3. Press the Tune button to get into adjust the radio frequency.

4. Press and hold the + or – button for 2 seconds, the unit will scan upward or downward

until a station with strong signal is searched and stops at this station.

5. You can adjust the frequency manually by pressing the + or – button when the radio

frequency is still displayed.

6. Press the Volume button to get into the volume adjusting mode, then press the + or –

button to adjust the volume to the desired level.

PRESET RADIO STATION

1. Press the ON/OFF button to turn on the radio.

2. Press and hold the TUNE/VOLUME button for approximate 2 seconds to select the band.