Cisco 8821-EX Manuale degli accessori - Pagina 18

Sfoglia online o scarica il pdf Manuale degli accessori per Telefono IP Cisco 8821-EX. Cisco 8821-EX 30. Wireless ip phone
Anche per Cisco 8821-EX: Manuale di avvio rapido (2 pagine)

Stampa la pagina

Charge Your Phone with the Multicharger

Step 5

Plug the jack end of the power cord into the multicharger.

Step 6

Plug the other end of the power cord into the power adapter.

Step 7

Plug the power adapter into the electrical outlet.

Charge Your Phone with the Multicharger

You can tell when your phone is charging in the multicharger when the LED beside the phone lights red.

When the battery is fully charged, the LED turns off. Your phone can take up to 3 hours to recharge.

If your phone has a protective case, you don't need to remove the case before you charge the phone in the

multicharger. You adapt the multicharger to fit the phone.

When you put the phone into the multicharger, make sure that you align the charging pins on the bottom of

the phone with the connector in the multicharger. If the LED does not light, then the alignment is not correct.

Do not charge the phone in a hazardous environment.

Caution

Do not charge the phone if it is wet.

Procedure

Step 1

(Optional) Reach into the cup with three fingers, locate the slots on the inside of the cup, and use the slots to

pull the cup out.

Cisco Wireless IP Phone 882x Series Accessory Guide

Cisco Accessories