ActronAir ERQ2-14AS Manuale di installazione - Pagina 9
Sfoglia online o scarica il pdf Manuale di installazione per Accessori per condizionatori d'aria ActronAir ERQ2-14AS. ActronAir ERQ2-14AS 20. Split ducted unit
Stampa la pagina
UNIT LIFTING PROCEDURES
A. CRANE LIFTING METHOD
NOTE: Crane lifting method is recommended for high rise lifting.
Connect the loop ends of slings unto shackle
Fig. 1
DANGER
Make sure rigging equipment, accessories and plant are
sufficiently and safely capable to lift the unit in order to
prevent potential damage to property, severe personal
injury or death. Please check unit weight and weight
distribution points on unit drawing dimensions section.
B. FORK LIFT METHOD
PROCEDURE:
1. To move the unit around with a forklift, insert the fork tines
through the unit feet assembly, as shown in Fig. 2.
2. Do not lift the unit through the electrical panel end of the unit
(See illustration for location of electrical panel end).
Fig. 2
INSERT FORKLIFT
TINES HERE
ActronAir is constantly seeking ways to improve the design of its products. Therefore, specifications are subject to change without notice.
Copyright © 2017 Actron Engineering Pty. Ltd.
WARNING
WH&S regulations must be observed and will
take precedence during lifting process.
EQUIPMENT REQUIRED FOR CRANE LIFTING:
- 1 x shackle
- 2 x nylon slings
- 4 x rubber pads
NOTE: Refer to catalogue for unit weight before selecting
shackles and slings.
PROCEDURE:
1. Slip nylon slings through the pallet as shown in Fig. 1.
2. Use a Bow or Dee shackle to connect the slings.
3. Ensure slings are protected by rubber pads or similar if slings
are draped across unit edges, corners, or air grilles . This will
prevent the unit from being damaged during lifting.
4. Test lift the unit to determine exact unit balance and stability
before hoisting it to the installation location.
A
Slip nylon slings
through the pallet
CAUTION
Length of fork lift tines must pass the unit
middle section, in order to safely carry the unit.
100
PALLET FORK LIFTING HOLE DIMENSIONS
All dimensions in mm.
ELECTRICAL
PANEL END
CAUTION
DO NOT LIFT UNIT from this end in order to
prevent damage to electrical panel and pipes.
Detail - A
675
100
675
100
38
Indoor
Unit
Pallet
38
624
Page 9 of 20