ActronAir LM7-2W Manuale di istruzioni per l'installazione - Pagina 3

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Controllore ActronAir LM7-2W. ActronAir LM7-2W 8. Wall controller

Stampa la pagina

1. 05. Enabling / Disabling Zones and Assigning Sensors

Installation Guide

01. Safety Precautions

Read all instructions in this manual before operating the air conditioning unit. Failure to do so may result in damage

to the unit and void your warranty.

2. Turn-Off the power supply to the unit and follow necessary Lock Out & Tag Out procedures to ensure that power

supply is not re-energised accidentally.

3. This control interface is connected to the wall controller terminal block on the Indoor board via screwed terminals

and 4 Core 14/0.20 0.44 mm Shielded Data Cable, with nominal voltage of 12VDC to 20VDC.

4. Make sure that the unit installation complies with all relevant council regulations and building code standards. All

electrical wiring must be in accordance with current electrical authority regulations and all wiring connections to be

as per electrical diagram provided.

5. WH&S rules and regulations must be observed and will take precedence during installation process.

6. Only use this Control Interface with an ActronAir air conditioner as described in this installation guide.

02. Specifications

• Voltage: 12VDC to 20VDC

• Operating conditions: -10 to 60

• Storage conditions: -20 to 70

• Data: 4 Core 14/0.20 0.44 mm Shielded Data Cable

• Dimensions - mm: 130 x 130 x 14.5 (W x H x D)

03. Installation

1. Remove front cover, as shown in the diagram below

• Insert and gently twist screwdriver into the slot at the side

of the Control Interface. Do this procedure alternately

between the two slots until the front of the control

separates from the back cover.

• Use large enough flat blade screwdriver to fit into the slot

in order to avoid damaging the Control Interface.

CONTROL

INTERFACE

SLOTS

ActronAir is constantly seeking ways to improve the design of its products, therefore specifications are subject to change without notice.

C, < 90% RH non-condensing

INSERT

SCREWDRIVER

AND TWIST

LM7-LM24 Control Interface

2. Remove back cover, as shown in the diagram below

• Insert and gently twist screwdriver into the slot at the top

and the bottom of the Control Interface. Do this procedure

alternately between the four slots until the back cover of

the control separates.

• Use large enough flat blade screwdriver to fit into the slot

in order to avoid damaging the Control Interface.

BACK COVER

SLOTS

PCB CASING

SLOTS