"When Having Some Trouble"
in User's Guide
Checking the indicators
You can check the status of the projector using the indicators on the projector's control panel.
Refer to the table below for details on checking and remedying the cause of problems.
Warning indicator
Power indicator
indicator
: lit
Problem and remedy
Status
Standby condition
The power cable should only be disconnected
when the projector is in this condition.
Orange
Press
on the projector's control panel
or
on the remote control to start
projection.
Orange
Cool-down in progress
After about 45 seconds, the projector will change
to standby mode (the indicator will light orange).
Green
Projection in progress
Green
Warm-up in progress
After warm-up finishes, projection starts when an
image signal is input.
(Warning) indicator
Status
High temperature inside projector (overheating)
The lamp will turn off automatically and projection will stop.
Wait for about 5 minutes without operating the projector.
Red
After 5 minutes have elapsed, unplug the power cable and
then plug it back in again. The projector will return to its
previous condition.
Then press
the remote control to turn the power back on
: flashing
Red
Lamp problem
Remove the lamp and check if it is broken.
If the lamp is broken replace by a new lamp, or contact
your local dealer for further advise.
(0.5-second
intervals)
Red
Internal problem
Stop using the projector and ask for service.
(1-second
intervals)
Orange
High-speed cooling in progress. If the temperature rises too
high again, projection will stop automatically.
Check that the air inlet and air outlet are clear, and that the
internal room temperature is not too high.
*1 Contact your dealer for a spare lamp.
*2 For repairs, contact your dealer or the nearest address
provided at "International Warranty Conditions" in "Safety
Instructions/World-Wide Warranty Terms".
: lit
: flashing
Problem and remedy
on the projector's control panel or
on
*1
*2
Troubleshooting
Stampa la pagina