Cisco 1600 series Manuale di avvio rapido - Pagina 7
Sfoglia online o scarica il pdf Manuale di avvio rapido per Router di rete Cisco 1600 series. Cisco 1600 series 8. Rdiag router analog ipsec
Anche per Cisco 1600 series: Manuale di avvio rapido (12 pagine), Installazione o sostituzione manuale (10 pagine), Manuale di installazione dell'hardware (14 pagine)
Stampa la pagina
Verify Your Installation.
After the router is powered on, the following LEDs confirm that you have correctly installed your router.
LED
Location
SYSTEM PWR
Front
SYSTEM OK
Front
OK
Rear, to the left of the
Flash PC card slot
LNK
Rear, one next to each
10BaseT port
ETHØ ACT
Front
ETH1 ACT
Front
Any WAN
WAN interface card
interface card
front panel
LEDs
For More Information
For more information about installing and configuring your Cisco 1605 router, see the following documents:
•
Cisco 1600 Fast Step Software Quick Start Guide that is in the accessory kit.
•
Cisco 1600 Series Router Hardware Installation Guide that is in the accessory kit.
•
Cisco 1600 Series Software Configuration Guide that is in the accessory kit.
•
The Cisco Connection Online card that is in the accessory kit, which lists telephone numbers, e-mail
addresses, and World Wide Web URLs for getting information directly from Cisco Systems.
What to Look For
On means that power is being supplied to the router.
On means that the router software is loaded and functional. Blinking
means that the software is being loaded into router memory.
On means that the Flash PC card is correctly installed. If the LED is off,
refer to the hardware installation guide that came with the router for
instructions on how to re-install the card.
On means that the router is connected to a local Ethernet network
through this port. If you connected the router to a local network through
the AUI port, then the LNK LED next to the ETHERNET Ø 10BASET
should be off.
Blinking means that there is network traffic on the local Ethernet network
that is connected to the ETHERNET Ø 10BASET port or the
ETHERNET Ø AUI port (only one of these two ports should be
connected).
Blinking means that there is network traffic on the local Ethernet network
that is connected to the ETHERNET 1 10BASET port.
Refer to the documentation that came with the WAN interface card.
7