Cisco 1721 - VPN Security Router Bundle Manuale di avvio rapido - Pagina 5
Sfoglia online o scarica il pdf Manuale di avvio rapido per Router di rete Cisco 1721 - VPN Security Router Bundle. Cisco 1721 - VPN Security Router Bundle 17. Troubleshooting guide
Anche per Cisco 1721 - VPN Security Router Bundle: Manuale di installazione dell'hardware (11 pagine), Scheda tecnica (12 pagine), Manuale d'uso (48 pagine), Risoluzione dei problemi hardware (12 pagine)
Stampa la pagina
Figure 2
Connecting the Router to Your Local Network
M o d e
SE E
MA NU
AL BE
l
FO RE
C is c o
INS TA
DS U
LL AT
ION
1 7 2 1
56 K
W IC
C O N
0 O K
F D X
1 0 0
L IN K
1 0 /1 0
0 E T
H E R
N E T
A U X
10/100
Ethernet port
A U I
Straight-through
Ethernet cable
Connect the other end of the cable to a port on the hub or switch.
Step 2
6
Installing the WICs
Look for a WIC in one or both of the slots on the back of the router. If a card is already installed, it can be connected to a WAN
line in accordance with the <Emphasis>Cisco WAN Interface Cards Hardware Installation Guide that came with the card. To
install a card in either slot, follow these instructions.
Note
If you are installing a WIC in the router for the first time, install the card in the WIC0 slot to ensure that your software
configuration will not be affected if you install a second card at a later time.
Step 1
Set the power switch to the STANDBY (
Caution
Power must be removed from the system prior to installing or removing WICs to avoid damaging them. When WICs
are pushed into or pulled out of a router that is powered up, it is likely that they could be damaged electrically and
will no longer function.
Remove the screws that hold the slot cover in place, as shown in Figure 3, and then remove the slot cover. You should
Step 2
be able to loosen the screws using your fingers; however, if the screws are very tight, you might need to use a Phillips
screwdriver.
S O LE
M O D
O K
W IC 1
O K
+ 5 , +
1 2 , -1
2 V D
C
(10, 100, or 10/100 Mbps)
8
7
6
5
4
3
2
1
Ethernet hub or switch
) position and confirm the router is not connected to the power supply.
5