Cisco 2524 - Router - EN Manuale di configurazione - Pagina 3

Sfoglia online o scarica il pdf Manuale di configurazione per Router di rete Cisco 2524 - Router - EN. Cisco 2524 - Router - EN 23. Troubleshooting guide
Anche per Cisco 2524 - Router - EN: Manuale di configurazione (23 pagine), Panoramica (10 pagine), Preparazione all'installazione (19 pagine), Manuale di risoluzione dei problemi (4 pagine)

Using Conﬁguration Mode

You can conﬁgure the router manually if you prefer not to use AutoInstall or the System

Conﬁguration Dialog. Take the following steps to conﬁgure the router manually:

Step 1

Step 2

Step 3

Step 4

Step 5

To see the current operating conﬁguration, enter the show running-conﬁg command at the

enable prompt:

Router# show running-config

To see the conﬁguration in NVRAM, enter the show startup-conﬁg command at the enable

prompt:

Router# show startup-config

Connect a console terminal following the instructions in the section "Connecting

the Console Terminal and Modem" in the chapter "Installing the Cisco 2524 and

Cisco 2525 Routers," and then power ON the router.

When you are prompted to enter the initial dialog, enter no to go into the normal

operating mode of the router:

Would you like to enter the initial dialog? [yes]: no

After a few seconds you will see the user EXEC prompt (Router>). Enter the

enable command to enter enable mode. You can only make conﬁguration changes

in enable mode.

Router> enable

The prompt changes to the privileged EXEC (enable) prompt:

Router#

Enter the conﬁgure terminal command at the enable prompt to enter

conﬁguration mode:

Router# configure terminal

You can now enter any changes you want to the conﬁguration.

Press Ctrl-Z to exit conﬁguration mode.

Configuring the Cisco 2524 and Cisco 2525 Routers 4-3

Configuring the Router