Cisco 3745 Manuale di avvio rapido - Pagina 20

Sfoglia online o scarica il pdf Manuale di avvio rapido per Router di rete Cisco 3745. Cisco 3745 33. Non-proprietary security policy
Anche per Cisco 3745: Panoramica della soluzione (16 pagine), Istruzioni per l'aggiornamento (30 pagine), Manuale d'uso (48 pagine), Manuale di installazione (12 pagine)

Stampa la pagina

1. Initial Configuration Using the Cli (Manual Configuration)

Enter a hostname for the router (this example uses 3745):

Step 3

Configuring global parameters:

Enter hostname [Router]: 3745

The enable secret is a password used to protect access to privileged EXEC and configuration modes. This

password, after entered, becomes encrypted in the configuration.

Enter an enable secret password. This password is encrypted (more secure) and cannot be seen when viewing the

Step 4

configuration:

Enter enable secret: xxxx

The enable password is used when you do not specify an enable secret password, with some older software

versions, and some boot images.

Enter an enable password that is different from the enable secret password. This password is not encrypted (less secure)

Step 5

and can be seen when viewing the configuration:

Enter enable password: xxxx

The virtual terminal password is used to protect access to the router over a network interface.

Enter the virtual terminal password, which prevents unauthenticated access to the router through ports other than the

Step 6

console port:

Enter virtual terminal password: xxxx

Step 7

Respond to the following prompts as appropriate for your network:

Configure SNMP Network Management? [yes]: yes

Community string [public]:

Step 8

A summary of the available interfaces is displayed:

Note

The interface numbering that appears is dependent on the type of Cisco modular router platform and on the

installed interface modules and cards.

Current interface summary

Controller Timeslots D-Channel Configurable modes Status

T1 3/0

T1 3/1

Any interface listed with OK? value "NO" does not have a valid configuration

Interface

FastEthernet0/0

FastEthernet0/1

Step 9

Select one of the available interfaces for connecting the router to the management network:

Enter interface name used to connect to the

management network from the above interface summary: fastethernet0/0

Step 10 Respond to the following prompts as appropriate for your network:

Configuring interface FastEthernet0/0:

Use the 100 Base-TX (RJ-45) connector? [yes]:

Operate in full-duplex mode? [no]: yes

Configure IP on this interface? [yes]:

IP address for this interface: 10.1.1.1

Subnet mask for this interface [255.0.0.0] : 255.255.0.0

Class A network is 10.0.0.0, 16 subnet bits; mask is /16

pri/channelized

IP-Address

OK? Method Status

unassigned

Administratively up

unset

Protocol

down