Cisco 4000 Series Manuale di installazione - Pagina 13

Sfoglia online o scarica il pdf Manuale di installazione per Router di rete Cisco 4000 Series. Cisco 4000 Series 18. Upgrading memory
Anche per Cisco 4000 Series: Manuale (18 pagine), Preparazione all'installazione (11 pagine), Manuale di sostituzione (16 pagine), Manuale di aggiornamento (24 pagine)

If you have an older version of the chassis, use the ﬁrst of the following procedures to install the telco

rack-mount or wall-mount brackets. If you have a new version of the chassis, use the second

procedure to install the telco rack-mount or wall-mount brackets. After installing the brackets, use

the appropriate procedure to install the chassis in a telco rack or on a wall.

Installing Telco Rack-Mount or Wall-Mount Brackets into an Old Version of the Chassis

Take the following steps to install telco rack-mount or wall-mount brackets into the old version of

the chassis:

Step 1

Step 2

Step 3

Note

screw locations apply only to the wall-mount procedures.

Figure 14

19 x 19 x 1/2" or larger plywood

Remove the component tray from the system. Refer to the procedure described in the

section, "Preparing the Chassis for Rack-Mounting or Wall-Mounting."

Insert one rack-mount bracket into the slot on each side of the shell, sliding the bracket

straight into the shell's inner two-inch brackets.

Fasten the bracket to the shell on each side of the chassis shell with one M3 machine screw

(as shown in Figure 14).

Figure 14 shows screw locations for both telco rack-mounting and wall-mounting. The wood

Screw Locations for Telco Rack-Mount or Wall-Mount Brackets – Old Version of the

Chassis

board (if wall-mounted)

Overview of Telco Rack-Mounting and Wall-Mounting

Wood screws

Telco rack-mount

or wall-mount bracket

Cisco 4000 Series Rack-Mount and Wall-Mount Installation

Chassis shell

M3 machine

screw

Front of the chassis