C.T.M. HS-559 Manuale di servizio - Pagina 5
Sfoglia online o scarica il pdf Manuale di servizio per Scooter C.T.M. HS-559. C.T.M. HS-559 14.
Stampa la pagina
Trouble Shooting
3‐1
Scooter won't move when key in turned on,
Check Point
Check if the power is off
Check if the N‐D lever is in Neutral position
Check if the battery power is enough. (Battery
gauge is under 25%)
Check if the charger power cord is still plugged in
scooter
3‐2
Error Code
Flash Description
1
Battery low
2
Low battery fault
3
High battery fault
4
Current limit time‐out or
controller overheat
5
Park brake
6
Drive inhibit
Solution
Turn the power on.
Switch to D (drive) position. Turn off the power and
turn on again.
Recharge the battery and then retest.
Unplug the charger power cord.
Initial Check Points
The batteries are running low.
‐
Recharge the batteries
The batteries have run out of charge
‐
Recharge the batteries
‐
Check the battery and associated connections and wiring.
Battery voltage is too high, this may occur if overcharged and/or
traveling down a long slope.
‐
If traveling down a slope, reduce the speed to minimize the
amount of regenerative charging.
The motor has been exceeding its maximum current rating for too
long.
‐
The scooter may have stalled. Turn the controller off, leave for a
few minutes and turn back on again.
‐
The motor may be faulty. Check the motor and associated
connections and wiring.
Either a park brake release switch is active or the park brake is faulty.
‐
Check the park brake and associated connections and wiring.
‐
Ensure any associated switches are in their correct positions.
Either a stop function is active or charger inhibits or OONAPU
condition has occurred.
‐
Release the stop condition (seat raised etc.)
‐
Disconnect the battery charger.
‐
Ensure the throttle is in Neutral when turning the controller on.
Service Manual‐ CTM HS‐559
5