Ace 3196425 Manuale rapido - Pagina 2

Sfoglia online o scarica il pdf Manuale rapido per Accessories Ace 3196425. Ace 3196425 8. Wireless mechanical battery operated chime

Stampa la pagina

Attach back of case to door jamb or wall. Snap

front of push button on.

When attaching push button using double sided

tape, make sure the surface of the door jamb or

wall is clean.

Mount

Chime Unit

with Arrow

Pointing Up

Note: Most installations will not require you to change any code set-

tings on your chime and push button.

The push button and chime communicate by using a code that can be changed

by changing dip switch positions or removing and/or adding jumpers on both

the push button and chime. The code is factory set; however, there are 128

selectable codes that allow you to expand your system and prevent outside

interference. Other wireless products may cause interference and the sys-

tem may not function properly. Follow the instructions below for setting a

new code.

1. Open the cases and locate the jumpers on the push button and the dip

switches on the chime (see Figure 6).

2. The push button has eight different jumper locations and the chime has

seven dip switches. The jumper positions 1 through 7 are used for setting

the code.

3. To change the code, add and/or remove jumpers and change dip switch

positions as needed. It is recommended to only change one code position

at a time and then check to see if system is functioning properly. Note:

Code positions 1 through 7 must be exactly the same for both the push

button and chime for this system to function.

Note: Unit will come factory set with jumpers in locations 5, 6, and 7 on the

push button and dip switch locations 5, 6, and 7 in the "ON" position (see

Figure 6).

1 2 3 4 5 6 7

Figure 5

Code and Tune Settings

Code Settings

Attach chime unit using two

Holes for

screws and wall anchors pro-

Wall

vided. Insert screws into screw

Mounting

holes as shown in Figure 5.

Note: Using arrow inside

chime unit as a guide, mount

chime with arrow pointing up

(see Figure 5). Snap cover

onto chime base.

-2-

Figure 4

598-1149-00