CAB 4126C Manuale di istruzioni per il montaggio - Pagina 12

Sfoglia online o scarica il pdf Manuale di istruzioni per il montaggio per Apparecchiature industriali CAB 4126C. CAB 4126C 14. Stroke applicator

Stampa la pagina

Error Messages

4.1

Error Messages of the Printer

For detailed information about printer errors (e.g. 'Paper out', 'Ribbon out', etc.)  Check the operator's manual of the

printer.

Error treatment:

 Clearing the error results.

 Press the feed key to synchronize the label feed, remove the left over labels manually.

 Press the pause key to quit the error state.

After error correction, the label causing the error will be reprinted.

4.2

Error Messages of the Applicator

The following table contains an overview of applicator specific error messages and their possible causes. It also

suggests methods to resolve the problems:

Error Message

Air pressure ins.

Label not depos.

Lower position

Process Error

Refl. sensor blk.

Upper position

Vac. plate empty

Table 2

Error treatment:

 Clear the error results.

 Press the pause key to quit the error state.

Note!

In the case of errors check the  Service Manual for adjustment and settings.

Warning!

After the error has been resolved the pad will immediately move back to the starting position!

Danger of crushing hands and fingers by the moving pad!

 Do not reach into the zone of the moving pad and keep long hair, loose clothes, and jewelry distant.

After error correction, the printing of the label causing the error cannot be repeated without restarting the print job

except the error "Vac. plate empty" . In this case, the last label will be printed again after resolution via the

pause key and then pressing the Enter button

 In the application mode "Apply/Print" sends the signal "Print first label" or press the button

label to the tamp.

Possible Cause

Compressed air is switched off

Pressure to low < 4 bar

Pressure to high > 6 bar

Label has not been placed onto the product; after the pad has moved back the label is

still sticking to the pad.

Pad has not reached the starting position within 2s after the pad has left the labelling

position; or pad has left the starting position without authorization.

Process of labeling was interrupted via the I/O interface of the printer with the XSTP

signal.

There has been no change of the switch state at the upper sensor at the cylinder

between the start of the labelling process and the signal from the labelling position

sensor.

Pad is not in the starting position when the printer is switched on.

Pad has not reached the labelling position within 2s after the movement of the pad was

started.

Pad has left the printing position without authorization.

Label has not been picked up properly by the pad; or label fell off the pad before it could

be placed onto the product.

Error messages of the applicator

to send a printed