Cisco RV340 Series Manuale di configurazione facile - Pagina 2
Sfoglia online o scarica il pdf Manuale di configurazione facile per Router di rete Cisco RV340 Series. Cisco RV340 Series 12. Security router
Anche per Cisco RV340 Series: Manuale di avvio rapido (13 pagine), Manuale di avvio rapido (10 pagine)
Stampa la pagina
1
Connecting Equipment
1-1
Before You Begin
Before you begin the installation, make sure that you have the following equipment:
RV340 Router (the router)
Power Adapter
●
●
Ethernet Cable x 2
PC
●
●
Make sure that nothing is connected to the router and your PC settings are config -
ured to use DHCP. And power off all equipment, including the cable or DSL modem,
the computer, and the router.
1-2
Connecting Equipment
1
Connect the first Ethernet ca-
ble to the WAN port #1 of the
router, and the other end of
the cable to the Ethernet port
of your WAN device.
2
Connect the second Ethernet
cable to one of the LAN port
of the router, and the other
end of the cable to the Ether-
net port of your PC.
4
Connect the AC power cable
to the AC power connector of
the router and a grounded AC
outlet.
The power switch is on by default.
The power light on the front panel is
solid green when the power adapt-
er is connected properly and the
device is finished booting.
6
MEMO
During the system boot up, the PWR LED will progressively keep flashing until the system has
fully booted. At start up, the PWR, LINK/ACT and GIGIBIT LEDs of LAN #1 will flash. At 25 %
boot up, the PWR, LINK/ACT and GIGIBIT LEDs of LAN #1 and 2 will flash. At 50 % boot up,
the PWR, LINK/ACT and GIGIBIT LEDs of LAN #1, #2 and #3 will flash. At 75% boot up, the
PWR, LINK/ACT and GIGIBIT LEDs of LAN #1, #2, #3 and #4 will flash. The system boot time
will be less than 3 minutes typically. If the router is fully configured with all feature configuration
settings set to a maximum, it may take up to 7 minutes to fully boot the system.
1
Connecting Equipment
3
Power on the WAN device
and wait until the connec-
tion is active.
5
Power on the PC that you
connected to one of the
LAN port in step
❷
.
6
Confirm that the PWR LED
is solid green and the port
LEDs that you connected
to the WAN device and the
PC are green or blinking
green.
Cisco RV340 Series Security Router Easy Setup Guide