Cisco 7200 VXR Series Manuale di avvio rapido - Pagina 22
Sfoglia online o scarica il pdf Manuale di avvio rapido per Punto di accesso wireless Cisco 7200 VXR Series. Cisco 7200 VXR Series 48. Preparing for installation
Anche per Cisco 7200 VXR Series: Scheda tecnica (12 pagine), Manuale (14 pagine)
Stampa la pagina
5
Start and Configure the Router
Power Cable Connections
Caution
This unit might have more than one power cord. To reduce the risk of electric shock, disconnect the two power
supply cords before servicing the unit. Statement 83
Warning
The AC power supply has double pole/neutral fusing. Statement 188
Connect AC-Input Power
Note
When powering off the router, wait a minimum of 30 seconds before powering it on again.
Figure 16
Connecting the AC Power Cable
1
2
3
1
Power switch
2
AC power cable
3
PWR OK LED
Step 1
At the rear of the router, check that the power switch (1) is in the off (O) position.
Step 2
Slide the cable-retention clip (4) up, away from the AC port, and plug in the power cable (2).
Step 3
If you are installing the adjustable power cable-retention clip shown in Figure 16, follow these steps:
a. Remove the retention-clip wire and replace it with the new cable-retention clip wire.
b. Insert the plastic portion of the clip, and adjust it to the desired length.
Step 4
Secure the cable in the power supply AC port by sliding the cable-retention clip down until it fits around the connector.
The cable-retention clip provides strain relief for the AC power cable.
Step 5
If you require additional AC power cable strain relief, secure the cable to the power supply handle by inserting a nylon
cable tie through the hole (5) in the handle and around the cable.
22
4
5
4
AC power cable-retention clip
5
Hole for nylon cable tie