Cisco AIR-AP1020 - 1000 Series Lightweight Access Point Manuale di avvio rapido - Pagina 15

Sfoglia online o scarica il pdf Manuale di avvio rapido per Punto di accesso wireless Cisco AIR-AP1020 - 1000 Series Lightweight Access Point. Cisco AIR-AP1020 - 1000 Series Lightweight Access Point 44. Aironet 1000 series ieee 802.11a/b/g lightweight access points with external antennas

Stampa la pagina
Installation and Configuration

Pre-Installation Configuration

The following procedures are designed to ensure that your Cisco Aironet 1000 Series lightweight access
point physical installation and that initial operation goes as expected. If you are unable to prepare your
Cisco Aironet 1000 Series lightweight access point for deployment, this step also describes RMA
(Return Material Authorization) procedures.
Perform the following procedure on each Cisco Aironet 1000 Series lightweight access point BEFORE
deploying it in its final location.
•
•
If you are unable to perform the following procedure, refer to the
section.

Preparing a Version 3.0 Cisco Aironet 1000 Series Lightweight Access Point

If your Cisco Aironet 1000 Series lightweight access point has Operating System 3.0 or a later version
loaded on it, continue with this procedure.
This procedure is written assuming that you are preparing a version 3.0 Cisco Aironet 1000 Series
Note
lightweight access point to operate with a Cisco Wireless LAN Controller.
Configuration Setup
Figure 4
AP1020/1030 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with External Antennas - Quick Start Guide
78-17147-01
Preparing a Version 3.0 Cisco Aironet 1000 Series Lightweight Access Point
Alternate Method of Preparing a Version 3.0 Cisco Aironet 1000 Series Lightweight Access Point
for installation in a Version 3.0 deployment
Configuration Setup
Appliance
Layer 2/3
devices
APs and REAPs
Appliance mode
Pre-Installation Configuration
OR
"Obtaining Technical
Assistance"
Switch
Direct-connect
mode
5