Cisco AIR-LAP1042N-E-K9 Manuale introduttivo - Pagina 11

Sfoglia online o scarica il pdf Manuale introduttivo per Punto di accesso wireless Cisco AIR-LAP1042N-E-K9. Cisco AIR-LAP1042N-E-K9 35.

If the access point remains in this mode for more than five minutes, the access point is

Note

unable to find the Master Cisco wireless LAN controller. Check the connection between

the access point and the Cisco wireless LAN controller and be sure that they are on the

same subnet.

c. If the access point shuts down, check the power source.

d. After the access point finds the Cisco wireless LAN controller, it attempts to download the

new operating system code if the access point code version differs from the Cisco wireless

LAN controller code version. While this is happening, the Status LED blinks dark blue.

e. If the operating system download is successful, the access point reboots.

Configure the access point if required. Use the controller CLI, controller GUI, or Cisco WCS

Step 3

to customize the access-point-specific 802.11n network settings.

If the pre-installation configuration is successful, the Status LED is green indicating normal

Step 4

operation. Disconnect the access point and mount it at the location at which you intend to

deploy it on the wireless network.

If your access point does not indicate normal operation, turn it off and repeat the

Step 5

pre-installation configuration.

When you are installing a Layer 3 access point on a different subnet than the Cisco

Note

wireless LAN controller, be sure that a DHCP server is reachable from the subnet on

which you will be installing the access point, and that the subnet has a route back to

the Cisco wireless LAN controller. Also be sure that the route back to the Cisco

wireless LAN controller has destination UDP ports 5246 and 5247 open for CAPWAP

communications. Ensure that the route back to the primary, secondary, and tertiary

wireless LAN controller allows IP packet fragments. Finally, be sure that if address

translation is used, that the access point and the Cisco wireless LAN controller have

a static 1-to-1 NAT to an outside address. (Port Address Translation is not

supported.)