Cisco AIR-LAP1310G Istruzioni per il montaggio - Pagina 23

Sfoglia online o scarica il pdf Istruzioni per il montaggio per Punto di accesso wireless Cisco AIR-LAP1310G. Cisco AIR-LAP1310G 40. Cisco aironet 1300 series lightweight outdoor access point

Stampa la pagina

1. Mounting the Access Point

Routing Mast Cables

To route and connect cables, follow these steps:

Step 1

Unspool two 75-ohm cables the full length from the access point to the grounding block, laying them

out straight without kinks. Do not cut the cables until you know the total required length between access

point and grounding block.

Step 2

Install F-connectors on the access point end of each cable and connect the cables to the access point. The

cables should slope downward from the access point connectors (when the mast is raised) so that

moisture runs away from the access point during rainstorms. If necessary, form drip loops near the

connector.

Secure the cables to the mast using UV-stabilized Ty-Wraps or equivalent fasteners.

Step 3

Weather seal all coaxial connectors by wrapping them with the sealant tape provided with the installation

Step 4

kit. For more information, see the

Raising the Mast and Connecting Cables

To raise the mast and connect cables, follow these steps:

Tilt the mast assembly to the upright position, set the mast in its mounting base clamp, orient the antenna

Step 1

in the direction of the remote antenna, and secure the guy wires.

Tighten the mast clamp so the mast is secure but so that it can be rotated for final adjustments in

Step 2

positioning.

Warning

Caution

Find the building's grounding electrode system and then connect the mast to it using 6 AWG copper wire.

Step 3

For more information about attaching the ground lug to the access point, see

"Attaching the Housing Bracket to the Access Point" section on page

lug location.

Dress the cables along the path from the mast to the grounding block. Secure the cables as you go using

Step 4

UV-stabilized Ty-Wraps or equivalent fasteners.

78-17634-01

"Applying Coax Seal Tape" section on page

This equipment must be grounded. Never defeat the ground conductor or operate the

equipment in the absence of a suitably installed ground conductor. Contact the appropriate

electrical inspection authority or an electrician if you are uncertain that suitable grounding

is available. Statement 1024

To ensure correct installation and grounding, install the access point in compliance with your

local and national electrical codes: National Fire Protection Association (NFPA) 70, National

Electrical Code (U.S.); Canadian Electrical Code, Part I, CSA 22.1 (Canada); and if local or

national electrical codes are not available, refer to IEC 364, Part I through Part 7 (other

countries).

Cisco Aironet 1300 Series Lightweight Outdoor Access Point Mounting Instructions

Mounting the Access Point

24.

Step 3

and

Step 4

in the

28. See

Figure 11

for the ground