Ace FMC-150-HYD Series Manuale di istruzioni - Pagina 10
Sfoglia online o scarica il pdf Manuale di istruzioni per Pompa dell'acqua Ace FMC-150-HYD Series. Ace FMC-150-HYD Series 12. Hydraulic motor driven centrifugal pumps
Stampa la pagina
HYDRAULIC MOTOR REPAIR KITS
Ace hydraulic motor repair kits include all O-rings and seals necessary to rebuild the motor. The motor
model number and date code are stamped on the end plate below the ports. The 200 series kit will fit
all motors including those with "L", "N", or "R" designation. The 300 series kit will fit all motors including
those with "L" or "A" designations except 310 motors with G-5 or earlier date codes.
Motor Model
200 Series Motors (202, 203, 204, 206, 210)
300 Series Motors (304, 305, 306, 307, 310)
310 Motor (G-5 or earlier)
MOTOR REPAIR KIT INSTALLATION
NOTE: The seal cartridge comes on an installation bullet with a small diameter for storage and
a larger diameter for installation. The seal lips curve towards the larger diameter when properly
installed on the bullet. The seal should remain on the bullet until installation for best results.
DISASSEMBLY:
1. Remove motor from pump by removing four cap screws.
2. Remove seal retaining ring from drive plate if installed and discard.
3. Remove two 1/4" cap screws (200 series) or four 3/8" cap screws (300 series).
4. Draw or scribe a line on motor casing (end plate, drive plate, housing), note orientation, and
pull apart.
5. Remove idler gear/shaft assembly, drive gear, and drive shaft dowel pin.
Note: Failure to remove dowel pin will result in bushing damage.
6. Press or tap (non-marring hammer) drive shaft/bearing assembly, and seal cartridge out of
drive plate.
7. Remove and discard old "O" rings and seal cartridge. Check shaft for wear or grooving under
seal and replace if damaged.
Repair Kit Part Number
RK-BAC-75-HYD-L
RK-BAC-75-HYD-300-L
RK-BAC-75-HYD-310
Disassembly Step 6
8
Ace EDP#
41374
41362
41379