DigitaLinx DL-HDCAT-WP Manuale d'uso - Pagina 7
Sfoglia online o scarica il pdf Manuale d'uso per Convertitore multimediale DigitaLinx DL-HDCAT-WP. DigitaLinx DL-HDCAT-WP 12. Digital media converter package
Stampa la paginaEnsure the two Category Cables are plugged into the appropriate RJ45 Jack. The
wires should be routed RJ45-1 to RJ45-1 and RJ45-2 to RJ45-2. Ensure the modular
plugs are fully seated and locked into the receptacles. Category 5e or better UTP or
F/UTP (overall shielded) is recommended.
The recommended method for connection of devices to the Digital Media
Converter is listed in the following steps. Please ensure this order is followed to
enjoy the full function of the device.
1.) Ensure the digital video/audio source and display is turned off.
2.) Connect the digital video/audio source to the input port of the
DigitaLinx™ Digital Media Converter.
3.) Connect the digital display to the output port of the DigitaLinx™
Digital Media Converter.
4.) Power up the DigitaLinx™ Digital Media Converter.
5.) Power up the digital display.
6.) Power up the digital video/audio sources
7.) HDCP handshaking operation can take up to 20 seconds.
Green LED's will illuminate when complete.
8.) Check the LED power indicator and status indicators on the DigitaLinx™
Digital Media Converter. The signal indicators should be green when the
devices are correctly attached. See troubleshooting on Page 1-10 if the
LED's are not green.
Note: The unit can function without the DC power supply however HDMI.org does
not recognize or authorize devices using source device voltage (Pin 18 on your
video source) as part of their specification. If using this item for DVI or Video only
applications the DC power source can be removed. It is recommended to use the
DC power source for full operation of the device.
Installation
Digital Media Converter Package
1-6
|
Part #: DL-HDCAT-WP
|