Cabela's 9863 Manuale - Pagina 5

Sfoglia online o scarica il pdf Manuale per Tenda Cabela's 9863. Cabela's 9863 8. Screen tent

Step 7 (optional): Insert the vertical rods on either side of

the screen tent's door. Install ends into the pockets at the

top and bottom of each side of the doorway. It is

recommended to use these if any wind is present. (Photos 6)

Step 8: Install securing stakes on the tent. The stakes are

designed to be used on the inside grommets or the outside

tie downs. If there is little to no wind, stakes may be used in

the eyelet in each corner of the screen tent. Place the tip of

the stake on the inside of the eyelet and drive it into the

ground so the hook catches the eyelet and holds the tent in

place.

If wind is present you must use the outside tie downs.

Secure the tent by tying one end of the provided strings on

each metal loop on the outside of the hub and staking the

other end. (Photo 8)

Using the built in Wind Panels:

Locate the tie strings mounted on each end of the wind

panels. Untie and let the panel fall down. Locate the hub

strap on the center of the wall and pull it through the

grommet on the wind panel. Zip down the zippers located on

each side of the wind panels. Finish with securing the Velcro

tabs on the outside of the zipper. To store the wind panels,

simply detach the Velcro tabs and unzip the wind panels.

Roll the panel back up and tie with tie strings.

Using the Awning Feature:

To use the awning feature on your screen tent, unzip the

zippers on each side of the attached wind panels. Install the

fiberglass pole into the pockets on each end of the lower,

bottom side of the wind panel. Using the aluminum poles

with the pins located at the top, install the pins through the

grommets at each corner. You can now attach a tie string

from the webbed loop at the corner of the wind panel and

run it to a stake approximately 3 ft out from the edge of the

awning. (Photos 8 & 9)

Photo 6

Photo 5

Photo 8

Photo 9