Cisco Meraki MR53E Manuale di installazione - Pagina 8

Sfoglia online o scarica il pdf Manuale di installazione per Punto di accesso wireless Cisco Meraki MR53E. Cisco Meraki MR53E 18.

Link Aggregation

The second Ethernet port can be used in a bonded configuration with the "PoE" port. Ensure that the AP is

plugged into 2 switch ports on the same Ethernet switch that have been configured for LACP bonding. Keep in

mind that the maximum bonded aggregate bandwidth is 2.0 Gbps. See the

Guide

for more details

Power Source Options

The MR53E access point can be powered using either the Meraki AC Adapter, PoE Injector (both sold separately), or a

third-party PoE switch.

Keep in mind that only the primary uplink will draw PoE.

The MR53E both will function in low power mode when powered by a 802.3af power source. While in low power

mode, MR53E will disable its Air Marshal radio as well as three out of four transmit streams on the 2.4 Ghz

band. Despite being in low power mode, the device can still supply full 802.11ac capabilities.

When using Cisco switches, an extra step may be required to configure the Cisco switch to use LLDP to

communicate with the Meraki MR53E; see the following article for more

details:

https://documentation.meraki.com/MR/Other_Topics/Low_Power_Mode_on_Cisco_Switches

Factory Reset Button

If the button is pressed and held for at least ﬁve seconds and then released, the AP will reboot and be restored to its

original factory settings by deleting all configuration information stored on the unit.

LED Indicators and Run Dark Mode

Your MR53E is equipped with a multi-color LED light on the front of the unit to convey information about system

functionality and performance:

• Orange - AP is booting (permanent Orange suggests hardware issue)

• Rainbow - AP is initializing/scanning

• Blinking Blue - AP is upgrading

• Green - AP in Gateway mode with no clients

• Blue - AP in Gateway mode with clients

• Blinking Orange - AP can't find uplink

The MR53E may be operated in

In this mode, the LED will not be illuminated.

"Run

Dark" mode for additional security and to reduce the visibility of the access point.

MR Link Aggregation Configuration