Cisco Meraki MR76 Manuale di installazione - Pagina 10

Sfoglia online o scarica il pdf Manuale di installazione per Punto di accesso wireless Cisco Meraki MR76. Cisco Meraki MR76 27.

Stampa la pagina

Choose Your Mounting Location

A good mounting location is important to getting the best performance out of your MR76 access point. Keep the following in mind:

1. The device should have unobstructed line of sight to most coverage areas.

2. Power over Ethernet supports a maximum cable length of 300 ft (100 m).

3. If being used in a mesh deployment, the MR76 should have line of sight to at least two other Meraki devices.

4. The antennas should be as unobstructed as possible. Make sure that there is clearance around the MR76 for

installation of all of your chosen antennas.

Install the MR76

For most mounting scenarios, the MR76 mount cradle provides a quick, simple, and ﬂexible means of mounting your device. The installation should be done in

two steps. First, install the mount cradle to your selected location. Then, attach the MR76 to the mount cradle.

Remove the Mount Plate from the Access Point

Before installing the mount plate, you must remove it from the back of the access point.

1. Unscrew the mount plate attachment screw.

2. Lift the mount plate release tab upwards.

3. While holding the mount plate release tab up, slide the mount plate off the access point in the direction shown

below.

Attach the mount cradle

The MR76 mount plate can be used to install your access point in a wide range of scenarios.

Wall or Solid Ceiling Mount Using mount cradle

Using included wall anchors and screws, attach the mount plate to your mounting wall or ceiling.