Cisco MR18 Manuale di installazione - Pagina 6
Sfoglia online o scarica il pdf Manuale di installazione per Punto di accesso wireless Cisco MR18. Cisco MR18 16.
Anche per Cisco MR18: Manuale rapido (2 pagine)
Stampa la pagina
Factory Reset Button
If the button is pressed and held for at least five seconds and then released, the MR18 will reboot and be restored to its
original factory settings by deleting all configuration information stored on the unit.
LED Indicators and Run Dark Mode
Your MR18 is equipped with a multi-color LED light on the front of the unit to convey information about system
functionality and performance:
• Orange - AP is booting (permanent Orange suggests hardware issue)
• Rainbow - AP is initializing/scanning
• Blinking Blue - AP is upgrading
• Green - AP in Gateway mode with no clients
• Blue - AP in Gateway mode with clients
• Blinking Orange - AP can't find uplink
The MR18 may be operated in "Run Dark" mode for additional security and to reduce the visibility of the access point. In
this mode, the LED will not be illuminated. This mode may be enabled through Meraki dashboard.
UL 2043 Plenum rating
The MR18 meets the UL 2043 plenum-rating standard. This certifies that the MR18 has adequate fire resistance and low
smoke-emission characteristics to be mounted and operated in a building's environmental air spaces, such as above
suspended ceilings in an office environment.
Pre-Install Preparation
You should complete the following steps before going on-site to perform an installation.
Configure Your Network in Dashboard
The following is a brief overview only of the steps required to add an MR18 to your network. For detailed instructions
about creating, configuring and managing Meraki wireless networks, refer to the online documentation
(documentation.meraki.com/mr).
1. Login to http://dashboard.meraki.com. If this is your first time, create a new account.
2. Find the network to which you plan to add your APs or create a new network.
3. Add your APs to your network. You will need your Meraki order number (found on your invoice) or the serial
number of each AP, which looks like Qxxx-xxxx-xxxx, and is found on the bottom of the unit. You will also need
your Enterprise license key, which you should have received via email.
4. Go to the map / floor plan view and place each AP on the map by clicking and dragging it to the location where you
plan to mount it.
6