Cisco Small Business WAP551 Manuale di avvio rapido - Pagina 5
Sfoglia online o scarica il pdf Manuale di avvio rapido per Punto di accesso wireless Cisco Small Business WAP551. Cisco Small Business WAP551 13. Reboot and reset to factory default settings
Anche per Cisco Small Business WAP551: Scheda tecnica (8 pagine), Recensione (6 pagine), Quide di avvio rapido (13 pagine), Opuscolo e specifiche (4 pagine), Manuale (4 pagine)
Stampa la pagina
To mount the WAP device to a wall or ceiling:
Determine where you want to mount the device. Verify that the
S
1
TEP
surface is smooth, flat, dry, and sturdy.
Drill two pilot holes into the surface 2.75 inches (70 mm) apart for
S
2
TEP
your Cisco WAP device.
Insert a screw into each hole, leaving a gap between the surface
S
3
TEP
and the base of the screw head.
Place the upper slots of the bracket over the screws, adjust the
S
4
TEP
screws accordingly, and slide the bracket down until the screws fit
snugly into the slots.
Using the bracket as a template, drill two more holes for the lower
S
5
TEP
screws.
Insert a screw into each lower hole.
S
6
TEP
Slide the WAP device into the bracket, placing the cable through
S
7
TEP
the break-out tab found in the back of the bracket.
Connecting the Cisco WAP551 and
4
WAP561 Wireless-N Access Points
The default configuration of the device has the Wi-Fi radio turned off. You
must perform the initial configuration using a wired Ethernet connection. To
connect the device to the wired network:
Connect the Ethernet cable to the Ethernet port of a switch, a router,
S
1
TEP
or a PC.
Connect the other end of the network Ethernet cable to the
S
2
TEP
Ethernet port of the wireless access point.
After installation, all lights should be active. Refer to
Hardware Installation, page 6
switch.
Cisco WAP551 and WAP561 Wireless-N Access Points
for details about the different lights on each
Verifying the
5