Cisco WAP121 Manuale di avvio rapido - Pagina 3
Sfoglia online o scarica il pdf Manuale di avvio rapido per Punto di accesso wireless Cisco WAP121. Cisco WAP121 13. Reboot and reset to factory default settings
Anche per Cisco WAP121: Recensione (6 pagine), Scheda tecnica (7 pagine), Opuscolo e specifiche (4 pagine), Manuale di avvio rapido (13 pagine), Manuale (4 pagine), Manuale (4 pagine)
Stampa la pagina
Cisco WAP121 and WAP321 Wireless-N
2
Access Point Features
Front Panel
The front panel of the devices consists of three lights: Power, WLAN, and
LAN. For full descriptions of the colors of the lights and their indications,
see
"Verifying the Hardware
under the lights.
Back Panel
The back panel of the devices consists of:
• Power Button—Use this button to turn the power on and off. It is not
applicable when using PoE.
• Power Jack—Use this jack if you are not using PoE.
• Kensington Lock Slot—Use to attach a cable and lock to the device.
• Reset—See
Factory Default Settings"
• RJ-45 Ethernet Port—Use this auto-sensing, Gigabit Ethernet (802.3)
port to connect to network devices, such as computers, routers, or
switches. Cisco strongly recommends using Cat5 or better cable for
Gigabit connectivity. You may use the Ethernet port to power your
device using PoE.
Default Settings
Parameter
Username
Password
LAN IP Address
Fallback LAN IP
Subnetwork Mask
If you are using a Cisco Small Business RV Series router, the default range
for the DHCP assigned address is from 192. 1 68. 1 . 1 00 to 192. 1 68. 1 .254. Any
device connecting to the same LAN will be assigned an IP address in this
range.
Cisco Small Business WAP121 and WAP321 Wireless-N Access Point with PoE
Installation". A Kensington lock slot is found
"Rebooting the Devices or Returning them to their
for information on the Reset button.
Default Value
cisco
cisco
DHCP address assigned
by server
192. 1 68. 1 .245
255.255.255.0
3