Cisco WAP150 Manuale di avvio rapido - Pagina 6
Sfoglia online o scarica il pdf Manuale di avvio rapido per Punto di accesso wireless Cisco WAP150. Cisco WAP150 13. Reboot and reset to factory default settings
Anche per Cisco WAP150: Manuale (4 pagine)
Stampa la pagina
- 1. Before You Begin
- 2. Cisco WAP150 Features
- 3. Mounting the Cisco WAP150
- 4. Wall Mounting
- 5. Placement Tips
- 6. Connecting the Cisco WAP150
- 7. Verifying the Hardware Installation
- 8. Getting Started with the Configuration
- 9. Suggested Next Steps
- 10. Troubleshooting
- 11. Rebooting the Cisco WAP150 or Resetting to Factory Defaults
- 12. Where to Go from here
After installation, all lights should be active. Refer to
Hardware Installation
WAP150.
Verifying the Hardware Installation
5
To verify the hardware installation, complete the following tasks:
• Check the cable connections.
• Check the state of the indicator light.
Label
Activity
Power
Off
Solid Green
Solid Blue
Solid Red
Flashing Green
Flashing Blue
LAN
Off
Solid Green
Solid Amber
Flashing
If you need help resolving a problem, visit the Cisco Support
N
OTE
Community at www.cisco.com/go/smallbizsupport.
Getting Started with the Configuration
6
To configure the Cisco WAP150, follow these steps to access the
web-based Configuration Utility and then the Setup Wizard from your
computer:
Connect the Cisco WAP150 to the same network (IP subnet) as your
S
1
TEP
computer. The factory default IP address configuration of the Cisco
6
for details about the different lights on the Cisco
Description
The WAP150 is out of power.
The Cisco WAP150 is normal; no wireless
client connected.
The Cisco WAP150 is normal; at least one
wireless client connected.
The Cisco WAP150 fails to boot with both
firmware images.
The Cisco WAP150 is booting.
Firmware upgrade is in progress.
No Ethernet link.
Gigabit Ethernet link is active.
Fast Ethernet link is active.
Transmitting or receiving data.
Verifying the
Cisco WAP150 Quick Start Guide