Cisco WUMC710 Manuale d'uso - Pagina 15

Sfoglia online o scarica il pdf Manuale d'uso per Punto di accesso wireless Cisco WUMC710. Cisco WUMC710 17. 802.11ac
Anche per Cisco WUMC710: Manuale di installazione rapida (17 pagine), Manuale d'uso (17 pagine)

Stampa la pagina

Linksys WUMC710

Troubleshooting

WUMC710

Your computer or other wired, Ethernet device cannot communicate with the

wireless router.

1. Access the media connector's browser-based utility

2. On the Basic Wireless Settings screen, make sure the Network Name (SSID)

matches the name of your wireless network

3. Make sure the security settings (WPA, WPA2, or WEP) match the security

settings of your wireless network

The media connector's IP address needs to be changed.

If the media connector is connected to a network with a DHCP server (usually

the network router), then the media connector will obtain its IP address from

the DHCP server If there is no DHCP server, then the media connector will use

its default, static IP address, 10.100.1.1

If you want the media connector to always use a static IP address, then follow

these instructions:

1. Access the media connector's browser-based utility

2. Click the Setup tab, then open the Basic Setup page

3. From the Network Setup drop-down menu, select Static IP

4. Complete the Static IP Address, Subnet Mask, and Default Gateway fields

5. Click Save Settings

The media connector-enabled computer or other wired, Ethernet device will

not communicate with another wireless-enabled device (such as a computer

or printer).

Check the following:

Make sure the wireless-enabled device is on the same wireless network

•

as the computer or other wired, Ethernet device connected to the media

connector

Make sure that the same Network Name (SSID) is used for all devices on

•

the wireless network

Make sure all devices are on the same IP network, using compatible IP

•

addresses

The browser-based utility does not accept your password.

Check the following:

The password is case-sensitive Make sure that you are using the correct

•

case(s) when entering the password

If you forget your password, you can reset the media connector to its

•

factory defaults

Press and hold the media connector's Reset button for approximately

five seconds; the password will be reset to its factory default, admin All

other media connector settings will be reset to the factory defaults as

well (To access the browser-based utility, enter admin in the Password

field )

After you make changes through the browser-based utility, the new settings

are not displayed on-screen.

On your web browser, click Refresh If the new settings are not displayed, then

follow these instructions:

1. Unplug the power adapter from the media connector

2. Wait five seconds, and then plug the power adapter back into the media

connector

3. On your web browser, click Refresh

WEB

If your questions are not addressed here, refer to the Linksys

website at Linksys.com/support

Troubleshooting